EN User Manual Hob ZGG62444 GB
Contents Safety information Safety instructions Product description Daily use Hints and tips 2 3 5 6 7 Care and cleaning Troubleshooting Installation Technical information Energy efficiency 7 8 9 13 14 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
• • • • • • • • Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. Do not store items on the cooking surfaces. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Do not use a steam cleaner to clean the appliance.
• • • • • • • • • • • • • • • • Before carrying out any operation make sure that the appliance is disconnected from the power supply. Make sure that the electrical information on the rating plate agrees with the power supply. If not, contact an electrician. Make sure the appliance is installed correctly. Loose and incorrect electricity mains cable or plug (if applicable) can make the terminal become too hot. Use the correct electricity mains cable. Do not let the electricity mains cable tangle.
• • • • • • • • • • • • • Do not let cookware to boil dry. Be careful not to let objects or cookware fall on the appliance. The surface can be damaged. Do not activate the cooking zones with empty cookware or without cookware. Do not put aluminium foil on the appliance. Use only stable cookware with the correct shape and diameter larger than the dimensions of the burners. Make sure cookware is centrally positioned on the burners.
Control knob Symbol Symbol Description no gas supply / off position Description ignition position / maximum gas supply minimum gas supply Daily use 1. Push the control knob down and turn it counterclockwise to the maximum gas WARNING! Refer to Safety chapters. Burner overview A supply position ( ). 2. Keep the control knob pushed for equal or less than 10 seconds. This lets the thermocouple warm up. If not, the gas supply is interrupted. 3. Adjust the flame after it is regular.
Turning the burner off WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. To put the flame out, turn the knob to the off position . Hints and tips CAUTION! WARNING! Make sure that pot handles are not above the front edge of the cooktop. Refer to Safety chapters. Cookware CAUTION! CAUTION! Do not use cast iron pans, potstones, earthenware, grill or toaster plates. The stainless steel can become tarnished if it is too much heated.
necessary, remove stubborn stains with a paste cleaner. 3. After you clean the pan supports, make sure that they are in correct positions. 4. For the burner to operate correctly, make sure that the arms of the pan supports are aligned with the centre of the burner. Cleaning the hob • Remove immediately: melted plastic, plastic foil, and food with sugar. If not, the dirt can cause damage to the hob.
Labels supplied with the accessories bag Stick the adhesive labels as indicated below: A B MOD. MOD. PROD.NO. PROD.NO. SER.NO SER.NO DATA DATA C MOD. PROD.NO. SER.NO. 0049 TYPE IP20 03 IT MADE IN ITALY A) Stick it on Guarantee Card and send this part (if applicable). B) Stick it on Guarantee Card and keep this part (if applicable). C) Stick it on instruction booklet. Installation WARNING! Refer to Safety chapters.
For appliances installed in the Republic of Ireland please refer to the NSAI- Domestic Gas Installation I.S. 813 Current Editions Table Four. Location The hob may be located in a kitchen, a kitchen/ diner or bed sitting room (with a volume greater than 20 m³), but not in a bathroom or shower room. The minimum distance combustible material can be fitted above the hob in line with the edges of the hob is 400 mm. If it is fitted below 400 mm a space of 50 mm must be allowed from the edges of the hob.
Adjustment of minimum level The manufacturer refuses to be held responsible, if these safety measures are not abided by. To adjust the minimum level of the burners: 1. 2. 3. 4. Light the burner. Turn the knob on the minimum position. Remove the knob. With a thin screwdriver, adjust the bypass screw position (A). A Supply connections This hob has to be connected to 220-240 V ~ 50/60 Hz ) electricity supply.
Building In Green and yellow - Earth Blue - Neutral Brown - Live min. 600 mm min. 100 mm min. 650 mm min. 55 mm WARNING! A cut off plug inserted into a 13 amp socket is a serious shock hazard. Ensure that the cut off plug is disposed of safely. 30 mm 470 mm 550 mm Replacement of the connection cable The replacement of electric cable must be carried out exclusively by the service force centre or by personnel with similar competencies, in accordance with the current regulations.
Kitchen unit with oven The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit.
Gas burners for LPG G30/G31 28-30/37 mbar BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK 1/100 mm NOMINAL GAS FLOW g/h G30 28-30 mbar G31 37 mbar Rapid 2,8 0,75 86 204 200 Semi-rapid 2,0 0,45 71 145 143 Auxiliary 1,0 0,33 50 73 71 Energy efficiency Product information according to EU 66/2014 Model identification ZGG62444SA Type of hob Built-in hob Number of gas burners 4 Energy efficiency per gas burner (EE gas burner) Left rear - Semi-rapid 59.
www.zanussi.
867321560-A-192015 www.zanussi.
