EN User manual Hob ZGF780IT GB IE
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ Product description _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ 2 3 5 5 6 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Troubleshooting _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Technical information _ _ _ _ _ _ _ _ _ _ _ _ 13 Environment concerns _ _ _ _ _ _ _ _ _ _ _ 14 Subject t
• Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. • Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. • Do not store items on the cooking surfaces. • Do not use a steam cleaner to clean the appliance. • Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot.
moved from the holder), earth leakage trips and contactors. Gas connection • All gas connections should be made by a qualified person. • Make sure that there is air circulation around the appliance. • The information about the gas supply is on the rating plate. • This appliance is not connected to a device, which evacuates the products of combustion. Make sure to connect the appliance according to current installation regulations. Pay attention to requirements regarding adequate ventilation.
Disposal Warning! Risk of injury or suffocation. • Contact your municipal authority for information on how to discard the appliance correctly. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. • Flat the external gas pipes.
Warning! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute. A B Important! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position.
Burner Diameters of cookware Front semi-rapid 120 - 180 mm Rear semi-rapid 120 - 220 mm Auxiliary 80 - 180 mm Warning! Make sure that the bottoms of pots do not stand above the control knobs. If the control knobs are under the bottoms of pots, the flame heats them up. Do not put the same pan on two burners. Warning! Make sure that pot handles is not above the front edge of the cooktop.
Removing the dirt: 1. – Remove immediately: melting plastic, plastic foil, and food containing sugar. – Stop the appliance and let it cool down before you clean: limescale rings, water rings, fat stains, shiny metallic discolorations. Use a special cleaner applicable for surface of hob. 2. Clean the appliance with a damp cloth and some detergent. 3. At the end rub the appliance dry with a clean cloth. The stainless steel can become tarnished if it is too much heated.
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local Service Force Centre. If you operated the appliance incorrectly, or the installation was not carried out by a registered engineer, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. • Product number (PNC) ................. • Serial Number (S.N.) .................
Provision for ventilation Detailed recommendations are contained in the following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891 Current Editions. The hob should not be installed in a bed sitting room with a volume of less than 20 m³. If it is installed in a room of volume less than 5 m³ an air vent of effective area of 100 cm² is required.
Rigid connection: Carry out connection by using metal rigid pipes (copper with mechanical end). Injectors replacement 1. Remove the pan supports. 2. Remove the caps and crowns of the burner. 3. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in "Technical Information" chapter). 4. Assemble the parts, follow the same procedure backwards. 5.
2. The supply system is equipped with an efficient earth connection in compliance with the current standards and regulations 3. The outlet or omnipolar switch used for connection is easily accessible with the appliance installed. The appliance is supplied with a 3 core flexible powercable with a 3 amp plug. If it is necessary to change the fuse, use a 3 amp ASTA-approved (BS 1362) fuse. A B 3. Connect the brown (live) wire to the terminal which is marked with the letter 'L'.
30 mm A a 60 mm min 20 mm (max 150 mm) b 10 mm 3 mm 86 mm 86 mm A a) Removable panel b) Space for connections Kitchen unit with oven The hob recess dimensions must obey the indication and the kitchen unit must be equipped with vents to let a continuous supply of air. The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit.
Electric supply: 230 V ~ 50 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Gas connection: R 1/2 " Category: II2H3+ Gas supply: G20 (2H) 20 mbar Appliance class: 3 By-pass diameters Burner Ø By-pass in 1/100 mm Burner Ø By-pass in 1/100 mm Auxiliary 28 Rapid 42 Semi-rapid 32 Triple Crown 56 Gas burners for NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW inj. 1/100 mm Auxiliary 1.0 70 Semi-rapid 2.0 96 Rapid 3.0 119 Triple Crown 4.
The packaging materials are friendly to the environment and can be recycled. The plastic components are identified by marking: www.zanussi.com >PE<,>PS<, etc. Discard the packaging materials as household waste at the waste disposal facilities in your municipality.
397183601-B-332012 www.zanussi.
