EN User manual Freezer ZFX305W
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful Hints and Tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 4 4 4 5 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2. • • • • Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover (if foreseen) of interior lighting. This appliance is heavy.
Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
Helpful Hints and Tips Normal Operating Sounds • You may hear a faint gurgling and a bubbling sound when the refrigerant is pumped through the coils or tubing. This is correct. • When the compressor is on, the refrigerant is being pumped around and you will hear a whirring sound and a pulsating noise from the compressor. This is correct. • The thermic dilatation might cause a sudden cracking noise. It is natural, not dangerous physical phenomenon. This is correct.
Defrosting the freezer A certain amount of frost will always form on the freezer shelf and around the freezing area. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Important! About 4-5 hours prior to defrosting, set the Temperature Regulator to "SUPER" position, in order to build up sufficient chill reserve for the interruption in operation. To remove the frost, follow the instructions below: 1. Switch off the appliance and disconnect the mains plug from the mains socket. 2.
Problem Possible cause Solution Doors are not shut properly or do not close tightly Check if the doors close well and the gaskets are undamaged and clean The door has been opened too frequently Do not leave the door open longer than necessary Large quantities of food to be frozen were put in at the same time Wait some hours and then check the temperature again Food placed in the appliance was too warm Allow food to cool to room temperature before storing The room temperature is too high.
Technical data Dimension Height 520 mm Width 525 mm Depth 587 mm Rising Time 17 h Voltage 230 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units.
2 1 1. Remove the plug from the power socket. 2. Remove the top hinge cover. 3. Unscrew the 2 retaining screws, and remove the hinge from the appliance. 4. Take the door off. 5. Remove the screw fixing the lower door hinge and the other screw fixing the lower door hinge and the foot. Then remove the door hinge and the foot as shown in the Figure. 6. Loosen the screw fixing the foot opposite the lower door hinge in order to remove the foot. 7.
5 Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the or coloured green and yellow. earth symbol 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3.
200383968-UK-01-31052011 www.zanussi.