EN User manual Freezer ZFX305W
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful Hints and Tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 4 4 4 5 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Environmental conc
squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover1) of interior lighting. • This appliance is heavy. Care should be taken when moving it.
Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rub- bish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
Helpful Hints and Tips Normal Operating Sounds • You may hear a faint gurgling and a bubbling sound when the refrigerant is pumped through the coils or tubing. This is correct. • When the compressor is on, the refrigerant is being pumped around and you will hear a whirring sound and a pulsating noise from the compressor. This is correct. • The thermic dilatation might cause a sudden cracking noise. It is natural, not dangerous physical phenomenon. This is correct.
er casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply. Defrosting the freezer A certain amount of frost will always form on the freezer shelf and around the freezing area. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm.
Problem Possible cause The compressor operates continually The thermostatic control is set incorrectly Solution Set a warmer temperature Doors are not shut properly or do not Check if the doors close well and the close tightly gaskets are undamaged and clean There is too much frost and ice The door has been opened too frequently Do not leave the door open longer than necessary Large quantities of food to be frozen were put in at the same time Wait some hours and then check the temperature again F
Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center. Technical data Dimension Height 520 mm Width 525 mm Depth 587 mm Rising Time 17 h The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label.
Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units.
7. Fix the door hinge and the corresponding foot on the opposite side and then 2 1 the other loosened foot at the former place of the door hinge as shown in the Figure. 8. Please make sure to place the lower foot below 1. Remove the plug from 5. Remove the screw fixthe door hinge. The lower the power socket. ing the lower door hinge foot is recognizable by its 2. Remove the top hinge and the other screw fixing 4 ribs on the outer surface. cover. the lower door hinge and 9. Fix the door onto the 3.
5 Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the or coloured green and yellow. earth symbol 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3.
200383525-UK-00-19052010 www.zanussi.