User manual

Problem Possible cause Solution
The appliance does not
operate. The Pilot light
does not flash.
The appliance is switched off. Switch on the appliance.
The mains plug is not connected to
the mains socket correctly.
Connect the mains plug to the mains
socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
The Pilot light flashes. The appliance is not working prop-
erly.
Contact a qualified electrician.
The Alarm light flashes. The temperature in the freezer is
too high.
Refer to "Excessive Temperature
Alarm"
The compressor operates
continually.
The temperature is not set correct-
ly.
Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too fre-
quently.
Do not keep the door open longer
than necessary.
The product temperature is too
high.
Let the product temperature de-
crease to room temperature before
storage.
The room temperature is too high. Decrease the room temperature.
The temperature in the
freezer is too low.
The temperature regulator is not set
correctly.
Set a higher temperature.
The Fast Freeze function is switch-
ed on.
Refer to" Fast Freeze function".
The temperature in the
freezer is too high.
The temperature regulator is not set
correctly.
Set a lower temperature.
Many products are stored at the
same time.
Store less products at the same
time.
Products are too near to each oth-
er.
Store products so that there is cold
air circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The temperature regulator is not set
correctly.
Set a higher temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
8
www.zanussi.com