EN User Manual Freezer ZFU25201WA
Contents Safety information Safety instructions Product description Operation Daily use 2 3 5 5 6 Care and cleaning Hints and tips Troubleshooting Installation Technical information 7 8 8 10 13 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
• • • • • • • Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents.
Use Care and cleaning WARNING! WARNING! Risk of injury, burns, electrical shock or fire. • • • • • • • • • • • • 4 Do not change the specification of this appliance. Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable.
Product description Product overview 1 2 3 5 4 1 Control panel 2 Flaps 3 Freezer drawers 4 Rating plate 5 Maxibox drawers Operation Control panel 1 1 Alarm light 2 QuickFreeze indicator www.zanussi.
5 Temperature regulator Switching on 1. Insert the plug into the wall socket. 2. Turn the temperature regulator clockwise to a medium setting. The Power indicator light and the Alarm light will light up. Switching off To turn off the appliance, turn the Temperature regulator to the "O" position. Temperature regulation The temperature is automatically regulated. 1. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. 2.
Thawing Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. The appliance is equipped with shelf stops to secure the shelves. The shelves must be lifted up (1) on each side and than pulled outwards (2). Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer.
Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 4. Leave the door/doors open to prevent unpleasant smells. WARNING! If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. 1. Disconnect the appliance from electricity supply. 2. Remove all food. 3. Clean the appliance and all accessories.
What to do if... Problem The appliance does not operate. Possible cause Solution The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The Alarm light flashes The temperature in the freezer is too high. Refer to 'High Temperature Alarm.
Problem Possible cause Solution Water flows on the floor. The melting water outlet is not connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray. Temperature cannot be set. The QuickFreeze or QuickChill function is switched on. Switch off QuickFreeze or QuickChill manually, or wait until the function resets automatically to set the temperature. Refer to "QuickFreeze or QuickChill function".
Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre. Location CAUTION! It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
letter “E“ or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp (E) is secure over the outer sheath. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. 5. Switch on the appliance.
1 3 3 2 2 1 5. Remove the door. 6. Position the pin and the washers on the opposite side (4). 12. Re-insert the cover pins (3) on the opposite side. CAUTION! Reposition, level the appliance, wait for at least four hours and then connect it to the power socket. 5 4 6 7. Unscrew the upper pin (1) and place it on the opposite side (2). 2 1 8. 9. 10. 11. Refit the door. Refit the plinth. Stand the appliance upright. Unscrew the handle (1) and fix it on the opposite side (2).
The technical information are situated in the rating plate, on the external or internal side of the appliance and in the energy label. ENVIRONMENT CONCERNS appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances.
www.zanussi.
280154849-B-492014 www.zanussi.
