User manual

21
If the malfunction shows again, contact the Service
Centre.
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to the
rating plate.
Model description ................................................
(Mod.)
Product number ................................................
(PNC)
Serial number ................................................
(S.N.)
Read the Safety information carefully for your
safety and correct operation of the appliance before
installation.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate class Ambient temperature
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be as least 100 mm. Ideally, however, the appliance
should not be positioned below overhanging wall units.
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
Warning! It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to your
domestic power supply. The appliance must be earthed.
The power supply cable plug is provided with a contact
for this purpose. If the domestic power supply socket is
not earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting a
qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed. This appliance
complies with the E.E.C. Directives.
For further technical information please refer to the
rating on the internal left side of the appliance and in
the energy label.
Technical data
Installation
Dimensions
Height 1440 mm
Width 554 mm
Depth 570 mm
Rising Time 10 hours
Levelling
The appliance should be level in order to eliminate
vibration. To make the appliance level, it should be
upright and both adjusters should be firmly in contact
with the floor. You can also adjust the level by screwing
out the appropriate level adjuster at the front (use your
fingers or a suitable spanner).