User manual

36
GB
Change of door opening direction
Should the setting-up place or handling demand it,
door-opening direction can be refitted from right-
handed to left-handed.
Following operations are to be done on the basis of
figures and explanations:
Break the circuit of the appliance.
Tilt back the appliance carefully being careful so
that the compressor can not touch the floor. It is
recommended to ask another person for help,
who can keep the appliance at this position
safely.
Unscrew the adjustable feet situated on both
sides (2 pieces), in addition the screws fixing the
lower door holders (3 pieces) and the screw on
the other side respectively.
Put over the pin in the lower door holding plate in
the direction of the arrow.
Take the door off.
Unscrew the top door holding pin and put it on
the other side.
Fit the door to the top door holding pin.
Fix the bottom door holders on the other side
being careful that the edge of the door is parallel
with the side of cupboard.
Then screw in the one screw in the place set free
on the other side as well as the adjustable feet (2
pieces) and set up the box.
Put over the handle and the plastic nails on the
other side.
Put the appliance to its place, set it level and
apply voltage to it.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
Electrical connection
This refrigerator is designed to operate on a 230
V AC (~) 50 Hz supply.
The plug must be put into a socket with
protective contact. If there is no such, it is
recommended to get an electrician to fit an
earthed socket in compliance with standards
near the refrigerator.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.02.73 (Low Voltage Directive) and
subsequent modifications,
- 89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.