User manual

33
GB
When placing the refrigerator keep minimal
distances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely
Switch and indicator unit
For the usage of the switching and indicator unit see
chapters "Putting it into use", "Controlling the
temperature" and "Freezing".
Components of the appliance are as follows:
A) Green indicator lamp
This lamp lights when the appliance is under
power, i.e. the mains plug is in the mains socket.
B) Red indicator lamp
It lights up depending on the temperature inside
the appliance.
It lights for a short time when starting the
appliance, placing fresh food into it and when the
temperature control knob has been turned in
direction to lower temperatures.
It lights permanently when the temperature inside
the appliance is too high (overloaded with warm
food, door stayed open or the door seal does not
close properly) or possibly the appliance was
broken down.
C) Yellow indicator lamp and freezer switch
In the switched-on state of the switch (pops up
and lights by pressing) the compressor operates
continuously thus providing for the coldest
interior temperature - achievable by the freezer -
needed for freezing.
D) Temperature control knob
This knob is provided for setting and changing
the temperature inside the appliance.
Putting it into use
Put the plug into the mains socket. Turn the
thermostatic control knob according to the figure.
This time the red lamp starts giving light, the
compressor starts and cooling begins shortly.
When the red light goes out the temperature is
sufficient and the appliance is suitable for storing
frozen and deep-frozen foods.
Controlling the temperature
The thermostatic controller interrupts the operation
of the appliance automatically for more or less time
depending on the setting then restarts it assuring the
required temperature.
Setting the thermostat knob can be done practically
with a coin. Turning the control knob clockwise
cooling becomes more and more intensive.
In the appliance -18 °C or lower temperature can be
reached if the thermostat knob is set according to the
figure.
The thermostat can be switched off („0” position),
which means breaking the circuit of the compressor
i.e. stopping cooling.
The temperature coming about in the freezer is
effected by not only the position of the thermostatic
control and the ambient temperature, but frequency
of door openings and the quantity of food put into it,
etc.
In maximum position of the thermostat - in
case of increased demand e.g. during
heatwaves - the compressor may operate
continually. This does not cause damages to the
appliance.
Freezing
Freezing different products should always be done in
the freezing compartment after proper preparation.
Switch on the freezer switch (pops up and lights by
pressing) 4 hours before freezing food of small
quantities and about 24 hours before freezing
products of larger quantities. This time the
compressor operates continuously to reach the
temperature necessary for freezing.
Place in the foods to be frozen and let the appliance
operate for about 24 hours as written above.
Then push the fast freezer switch again (the yellow
light will go out and the switch turns to its original
position).