EN User manual Chest Freezer ZFC51400WA
Contents Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ 2 4 4 5 5 5 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
nents of the refrigerant circuit become damaged. If the refrigerant circuit should become damaged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock.
• Make sure that the mains plug is accessible after the installation of the appliance. Service • Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. ther its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish.
First use Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Important! Do not use detergents or abrasive powders, as these will damage the finish. Daily use Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time.
• the freezing process takes 24 hours.
4. 5. 6. 7. When defrosting is completed, dry the interior thoroughly and refit the plug. Switch on the appliance. Set the temperature regulator to obtain the maximum coldness and run the appliance for two or three hours using this setting. Reload the previously removed food into the compartment. Important! Never use sharp metal tools to scrape off frost as you could damage the appliance.
Problem Possible cause Solution The cabinet has been recently switched on and the temperature is still too high. Refer to "High Temperature Alarm". Products are not wrapped properly. Wrap the products better. The lid is not shut properly or do not close tightly. Check if the lid closes well and the gaskets are undamaged and clean. The temperature is not set correctly. Set a warmer temperature. The water drainage plug is not correctly positioned.
Problem Possible cause Solution There is no voltage in the mains socket (try to connect another appliance into it). Customer Service If your appliance is still not working properly after making the above checks, contact the nearest service centre. To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found either on the guarantee certificate or on the rating plate located on the external right side of the appliance. 2.
The manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the E.E.C. Directives. Ventilation requirements 1. Put the freezer in horizontal position on a firm surface. The cabinet must be on all four feet. 2. Make sure that the clearance between the appliance and rear wall is 5 cm. 3. Make sure that the clearance between the appliance and the sides is 5 cm. The airflow behind the appliance must be sufficient.
www.zanussi.
804180580-HU-182013 www.zanussi.
