User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard.
• • • • • • Do not store flammable gas and liquid in the appliance. Do not put flammable products or items that are wet with flammable products in, near or on the appliance. Do not touch the compressor or the condenser. They are hot. Do not remove or touch items from the freezer compartment if your hands are wet or damp. Do not freeze again food that has been thawed. Obey the storage instructions on the packaging of frozen food.
24 hours to allow the correct temperature to be reached before placing food inside. The power indicator light will light up. 3. Adjust the Temperature Regulator according to the quantity of the stored foods. SWITCHING OFF Turn the Temperature regulator to the OFF position. TEMPERATURE REGULATION The temperature within the appliance is controlled by the Temperature Regulator situated on the control panel.
STORAGE BASKETS Hang the baskets on the upper edge of the freezer (A) or place them inside the freezer (B). Turn and fix the handles for these two positions as shown in the picture. A The baskets will slide into each other. 606 806 946 1061 230 1201 B 1336 1611 You can purchase additional baskets from your local Service Centre. The following pictures show how many baskets can be placed inside the various freezer models. HINTS AND TIPS WARNING! Refer to Safety chapters.
soap to remove the typical smell of a brand-new product, then dried thoroughly. CAUTION! Do not use detergents, abrasive powders, chlorine or oilbased cleaners as they will damage the finish. PERIODIC CLEANING CAUTION! Unplug the appliance before carrying out any maintenance operation. Do not use detergents, abrasive products, highly perfumed cleaning products or wax polishes to clean the inner side of the appliance. Prevent damage to the cooling system. There is no need to clean the compressor area. 1.
WHAT TO DO IF... Problem Possible cause The appliance does not operate. The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. There is no voltage in the mains socket. Connect to a different electrical mains socket. Contact a qualified electrician. The appliance is noisy. The appliance is not supported properly. Check if the appliance stands stable. Audible or visual alarm is on.
Problem The temperature in the appliance is too low/too high. Possible cause Solution The water drainage plug is not correctly positioned. Position the water drainage plug in the correct way. Temperature is set incorrectly. Refer to "Operation" chapter. The temperature regulator is not set correctly. Set a higher/lower temperature. The lid is not closed correctly. Refer to "Opening and closing the lid". The products' temperature is too high.
POSITIONING CAUTION! If you are discarding an old appliance that has a lock or catch on the lid, you must ensure that it is made unusable to prevent young children being trapped inside.
VENTILATION REQUIREMENTS The airflow behind the appliance must be sufficient. 1. Put the freezer in horizontal position on a firm surface. The cabinet must be on all four feet. 2. Make sure that the clearance between the appliance and rear wall is 5 cm. 3. Make sure that the clearance between the appliance and the sides is 5 cm.
804181572-A-012017 WWW.ZANUSSI.