EN User Manual Chest Freezer ZFC21400WA
Contents Safety information Safety instructions Operation Before first use Daily use 2 3 5 6 6 Hints and tips Care and cleaning Troubleshooting Installation Technical information 7 7 8 10 11 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
• • • • • • • Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents.
Use Care and cleaning WARNING! WARNING! Risk of injury, burns, electrical shock or fire. • • • • • • • • • • • • Do not change the specification of this appliance. Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable.
Operation Control panel 1 2 1 Temperature regulator 2 Power indicator light 3 High temperature alarm light 3 Switching on A) Temperature Regulator B) Half Loaded position C) Full Loaded position A B C 1. Insert the plug into the wall socket. 2. Turn the Temperature Regulator to the Full Loaded position and let the appliance run for 24 hours to allow the correct temperature to be reached before placing food inside. The power indicator light will light up. 3.
Before first use WARNING! Refer to Safety chapters. soap to remove the typical smell of a brand-new product, then dried thoroughly. CAUTION! Cleaning the interior Do not use detergents or abrasive powders, as these will damage the finish. Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral Daily use WARNING! Refer to Safety chapters.
Hints and tips WARNING! Refer to Safety chapters. • • Hints for freezing To help you make the most of the freezing process, here are some hints: • • • • • • The maximum quantity of food which can be frozen in 24 hours is shown on the rating plate. The freezing process takes 24 hours. No further food to be frozen should be added during this period. Freeze only top quality, fresh and thoroughly cleaned foodstuffs.
the outer environment humidity and if the frozen food is not wrapped properly. The best time to defrost the freezer when it contains no or only a little food. 1. Switch off the appliance. 2. Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. 3. When defrosting is completed, dry the interior thoroughly and refit the plug. 4. Switch on the appliance. 5.
Problem Possible cause Solution The valve is blocked. Check the valve. The lamp does not work. The lamp is defective. Refer to "Replacing the lamp". The compressor operates continually. Temperature is set incorrectly. Refer to "Operation" chapter. Large quantities of food to be frozen were put in at the same time. Wait some hours and then check the temperature again. The room temperature is too high. Refer to climate class chart on the rating plate. Food placed in the appliance was too warm.
Replacing the lamp WARNING! Do not remove the lamp cover at the time of replacement. Do not operate the freezer if the lamp cover is damaged or missing. 3. Connect the mains plug to the mains socket. 4. Open the lid. Make sure that the lamp comes on. 1. Disconnect the mains plug from the mains socket. 2. Replace the used lamp with a new lamp of the same power and specifically designed for household appliances (the maximum power is shown on the lamp cover).
A 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp (E) is secure over the outer sheath. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. 5. Switch on the appliance. The appliance is supplied with a 13 amp fuse (B). In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
ENVIRONMENT CONCERNS appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose 12 www.zanussi.
www.zanussi.
www.zanussi.
www.zanussi.
804181100-A-042015 www.zanussi.