User manual

The Safety Instructions
Warning! You must read these!
• Make sure that the appliance is not damaged because
of transportation. Do not connect a damaged appliance.
If it is necessary, speak to the supplier.
• Only an authorized servicing technician can install,
connect or repair this appliance. Use only original
spare parts.
• Only use the built-in appliances after you assemble the
appliance into correct built-in units and work surfaces
that align to the standards.
• Do not change the specifications or change this prod-
uct. Risk of injury and damage to the appliance.
• Fully obey the laws, ordinances, directives and stand-
ards in force in the country where you use the appli-
ance (safety regulations, recycling regulations, electri-
cal safety rules etc.)!
• Keep the minimum distances to other appliances and
units!
• Install shock protection, for example install the drawers
only with a protective floor directly below the appli-
ance!
• Keep safe the cut surfaces of the worktop from mois-
ture with a correct sealant!
• Seal the appliance to the work top with no space be-
tween with a correct sealant!
• Keep safe the bottom of the appliance from steam and
moisture, e.g. from a dishwasher or oven!
• Do not install the appliance adjacent to doors and be-
low windows! If not, when you open the doors or win-
dows they can push off hot cookware from the appli-
ance.
Warning! Risk of injury from electrical current.
Carefully obey the instructions for electrical
connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give shock protection.
• Loose and incorrect plug and socket connections can
make the terminal become too hot.
• A qualified electrician must install the connections in
the clamps correctly.
• Use a strain relief clamp on cable.
• Use the correct mains cable of type H05BB-F Tmax
90°C (or higher) for a single phase or two phase con-
nection.
• Replace the damaged mains cable with a special cable
(type H05BB-F Tmax 90°C; or higher). Speak to your
local Service Centre.
The appliance must have the electrical installation which
lets you disconnect the appliance from the mains at all
poles with a contact opening width of minimum 3 mm.
You must have correct devices to isolate: line protecting
cut-outs, fuses (screw type fuses removed from the hold-
er), earth leakage trips and contactors.
3