User manual Dishwasher Cancel ZDT 201
Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance.
Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
or if the control panel, work top or plinth area are damaged such that the inside of the appliance is freely accessible. Contact your local Service Force centre, in order to avoid hazard. • All sides of the dishwasher must never be drilled to prevent damage to hydraulic and electric components. Installation • Check your dishwasher for any transport damage. Never connect a damaged machine. If your dishwasher is damaged contact your supplier. • All packaging must be removed before use.
Setting mode The appliance is in setting mode when all programme lights are off and End of programme light flashes. IMPORTANT! Always remember that when performing operations such as: • selecting a washing programme • setting the water softener • deactivation/activation of the audible signals Delay start button the appliance MUST be in setting mode. If a programme light is illuminated and End of programme light is illuminated with fixed light, the last performed programme is still set.
Programme selection/cancel button • Starting the washing programme: 1. Press the On-Off button. 2. Press the Programme selection/cancel button once, the light of the last performed washing programme illuminates and the End of programme light flashes. 3. Press the Programme selection/cancel button as many times as necessary to illuminate the light corresponding to the desired programme. 4. Close the dishwasher’s door, the programme will start automatically.
Indicator lights Salt Illuminates when the special salt has run out. Is never illuminated while a washing programme is running. Audible signals Audible signals have been introduced to help indicate which operations the dishwasher is performing. – end of the washing programme, – malfunction of the appliance Factory setting: audible signals activated. It is possible to deactivate the audible signals, using the Programme selection/Cancel button. Deactivation/activation of the audible signals 1.
Washing programmes Programme Degree of soil Type of load Programme description Intensive 70° Heavy soil Crockery, cutlery, pots and pans Prewash Main wash 2 intermediate rinses Final rinse Drying Normal 65° Normal soil Crockery, cutlery, pots and pans Prewash Main wash 2 intermediate rinses Final rinse Drying 30 min Light soil Crockery and cutlery Main wash Final rinse Normal soil Crockery and cutlery Prewash Main wash 1 intermediate rinse Final rinse Drying 1) Bio 50° 2) Rinse and Hold
– Set the water hardness to level 1. When using tablets that integrate rinse aid and detergent: there is no need to fill up with rinse aid – set the water softener – add special (dishwasher) salt When using tablets that integrate rinse aid, detergent, salt function and other additives: there is no need to fill up with special salt or rinse aid. Check whether these detergents are suitable for your water hardness. Follow the manufacturers instructions.
Water hardness Adjusting the water hardness setting Use of salt Clarke °TH mmol/l manually electronically 46 - 52 65 - 75 6,5 - 7,5 2 level 8 yes 36 - 45 51 - 64 5,1 - 6,4 2 level 7 yes 28 - 35 40 - 50 4,0 - 5,0 2 level 6 yes 23 - 27 33 - 39 3,3 - 3,9 2 level 5 yes 18 - 22 26 - 32 2,6 - 3,2 1 level 4 yes 13 - 17 19 - 25 1,9 - 2,5 1 level 3 yes 5 - 12 7 - 18 0,7 - 1,8 1 level 2 yes <5 <7 < 0,7 1 level 1 no The water softener must be set in both ways: ma
4. To change the level, press the Programme selection/Cancel button. Each time the button is pressed the level increases (level 1 follows level 10). The End of programme light indicates the new setting. 5. To memorise the operation, switch off the dishwasher. Filling with dishwasher salt CAUTION! Use only special salt suitable for dishwashers. Unscrew the cap.
Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close the lid and press until it indicated by "max" locks. IMPORTANT! CAUTION! Top up the rinse aid when the light on the control panel Never fill the rinse aid dispenser with any other subilluminates. stances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance.
Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. • Before loading the dishes, you should: – Remove all left over food and debris. – Soften remnants of burnt food in pans • When loading the dishes and cutlery, please note: – Dishes and cutlery must not impede the rotation of the spray arms. – Load hollow items such as cups, glasses, pans, etc. with the opening downwards so that water cannot collect in the container or a deep base.
Load cutlery. For best results we recommend you to use the cutlery grid provided (if the size and dimensions of the cutlery allow it) Place knives and other items of cutlery with sharp points or edges with their handles facing upwards. Risk of injury! Load upper basket. Light items (plastic bowls etc.) must be loaded in the upper basket and arranged so they do not move. For taller items, the cup racks can be folded upwards. Load the lower basket.
IMPORTANT! When the basket is in the higher position you will not be able to use the cup racks. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. Use of detergent IMPORTANT! Only use detergents suitable for dishwashers. Open the lid. Observe the manufacturer’s dosing and storage recommendations. Fill in the detergent in compartment A. Observe the dosing levels.
For programmes with pre- When using detergent Close the lid. wash add an additional tablets: place detergent detergent dose in comtablets in compartment A. partmentB. Detergent tablets Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore, please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals.
Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing comwater. move filters B and C. partment. Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure clockwise to the stop. that it fits perfectly under the two guidesD. Cleaning the spray arms Internal cleaning NEVER try to remove the spray arms.
2. Leave the door ajar to prevent the formation of any unpleasant smells. 3. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. 1. Unplug it. 2. Turn the water tap off. 3. Remove the water inlet and discharge hoses. 4. Pull the machine out together with the hoses.
Something not working The dishwasher will not start or stops during operation. Certain problems are due to the lack of simple maintenance or oversights, which can be Fault code and malfunction solved with the help of the indications described in the chart, without calling out an engineer. Switch off the dishwasher and carry out the following suggested corrective actions. Possible cause and solution • continuous flashing of the start/cancel indicator • The water tap is blocked or furred with limescale.
For other fault codes not described in the above chart, please contact your Service Force Centre. Contact your local Service Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.). This information can be found on the rating plate located on the side of the dishwasher door.. So that you always have these numbers at hand, we recommend you to make a note of them here: Mod. :. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PNC : . . . . . . . . . . . . . . . . . . .
Consumption values iations of the power supply and the amount of dishes.
rinse aid respectively and using the test programme (see "Consumption values"). Full load: 12 standard place settings Amount of detergent required 5 g + 25 g (Type B) Rinse aid setting position 4 (Type III) Upper basket Cutlery basket Lower basket cup racks: position A Installation WARNING! Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person.
WARNING! Only use, for connection to the water mains, new hose-set; old hose-set must not be reused. you should run the water for a few minutes before connecting the inlet hose. CAUTION! If the machine is connected to new pipes or pipes which have not been used for a long time, Inlet hose Connect the inlet hose to a water tap with an external thread of 3/4”. The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut.
If you use a drain hose extension the total length should not be longer than 4 metres. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. Fitting under a counter Electrical connection WARNING! The dishwasher must be secured against tilting. Therefore make sure that the counter it is fixed under, is suitably secured to a fixed structure (adjacent kitchen units cabinets, wall).
www.electrolux.com www.zanussi-electrolux.co.
