EN User manual Dishwasher ZDT11001
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Options _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Before first use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 3 3 4 4 5 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Troubleshooting _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10
• Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. • Do not keep the appliance door open without supervision to prevent to fall on it. • Do not sit or stand on the open door. • Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging. • Do not drink and play with the water in the appliance. • Do not remove the dishes from the appliance until the programme is completed. There can be detergent on the dishes.
Indicators Description End indicator. Salt indicator. This indicator is off while the programme operates.
. Wait until the programme indicator (A) goes off and the end indicator comes on (the programme indicator (B) continues to flash). • The acoustic signals are on. 6. Press the programme button. The end indicator goes off. • The acoustic signals are off. 7. Deactivate the appliance to confirm. 2. Wait until the programme indicator (A) goes off. The end indicator is off and programme indicator (B) continues to flash. • The acoustic signals are off. 3. Press the programme button. The end indicator comes on.
Water softener adjustment Water hardness German degrees (°dH) French degrees (°fH) mmol/l Clarke degrees Manual Electronic 11 - 14 19 - 25 1.9 - 2.5 13 - 17 1 3 4 - 10 7 - 18 0.7 - 1.8 5 - 12 1 2 <4 <7 < 0.7 <5 12) 12) 1) Factory position. 2) Do not use salt at this level. Filling the salt container Manual adjustment Caution! Only use dishwasher salt. Other products can cause damage to the appliance. Water and salt can come out from the salt container when you fill it.
max X + MA 1 6 5 2 3 4 4 3 Filling the rinse aid dispenser max The rinse aid, during the last rinsing phase, helps to dry the dishes without streaks and stains. MA A 2 3 4 + X 1 MA X + Caution! Only use rinse aid for dishwashers. Other products can cause damage to the appliance. 1 2 1 2 3 4 Fill the rinse aid dispenser To adjust the released when the lens (A) is clear.
Using the detergent Combi detergent tablets Caution! Use only detergents for dishwashers. Do not use more than the correct quantity of detergent. Refer to the instructions on the detergent packaging. 1 2 A A 3 Put the detergent or the tablet in compartment (A). 1. Press the on/off button to activate the appliance. 2. Set the water softener to the highest level. 3. Make sure that the salt container and the rinse aid dispenser are full. 4.
Opening the door while the appliance operates If you open the door, the appliance stops. When you close the door, the appliance continues from the point of interruption. Cancelling the programme 1. Open the appliance door. 2. Press and hold the programme button until the indicator of the set programme goes off and the end indicator flashes. Make sure that there is detergent in the detergent dispenser before you start a new programme. At the end of the programme 1. Open the appliance door.
An incorrect position of the filters can cause bad washing results and damage to the appliance. D Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. A 5 Put filter (A) to its initial position. Make sure that it assembles correctly under the two guides (D). External cleaning Clean the appliance with a moist soft cloth. Only use neutral detergents.
Problem The appliance does not drain the water. Possible cause Possible solution The filter in the water inlet hose is clogged. Clean the filter. The water inlet hose has a kink or a bend. Make sure that the position of the hose is correct. The sink spigot is clogged. Clean the sink spigot. The water drain hose has a kink or a bend. Make sure that the position of the hose is correct. After the checks are completed, activate the appliance. The programme continues from the point of interruption.
Problem Possible cause Whitish streaks and stains or bluish layers on glasses and dishes. The released quantity of rinse aid is too much. Decrease the released quantity of rinse aid . The quantity of detergent was too much. Make sure that you add the correct quantity of detergent in the dispenser before you start a programme. The released quantity of rinse aid was not sufficient . Increase the released quantity of rinse aid. The quality of the detergent can be the cause.
156957970-A-332011 www.zanussi.