User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
• • • • • Do not keep the appliance door open without supervision to prevent to fall on it. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. The ventilation openings in the base (if applicable) must not be obstructed by a carpet. The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused.
• • The appliance can release hot steam if you open the door while a programme operates. Do not put flammable products or items that are wet with flammable products in, near or on the appliance. SERVICE • Contact the Authorised Service Centre to repair the appliance. We recommend only the use of original spare parts. • When you contact the Authorised Service Centre, ensure that you have the following information that is available on the rating plate.
EASY START 1 2 6 1 On/off indicator 2 Programme marker 3 5 4 5 Start button 6 Programme knob 3 Indicators 4 Delay button INDICATORS Washing phase. It comes on when the washing phase operates. Drying phase. It comes on when the drying phase operates. End indicator. Salt indicator. It is always off while the programme operates.
PROGRAMMES Consumption values 1) Programme Degree of soil Type of load Programme phases Duration (min) 2) 3) 4) 5) Energy (kWh) Water (l) Normal soil Crockery and cutlery • • • • Prewash Wash 50 °C Rinses Dry 195 1.039 11 Heavy soil Crockery, cutlery, pots and pans • • • • Prewash Wash 70 °C Rinses Dry 150 170 1.5 - 1.6 13 - 15 Normal soil Crockery and cutlery • • • • Prewash Wash 65 °C Rinses Dry 120 130 1.3 - 1.6 15 - 17 Fresh soil Crockery and cutlery • 30 0.
Do not use detergent and do not load the baskets. THE WATER HARDNESS TABLE German degrees (°dH) French degrees (°fH) mmol/l Clarke degrees Water softener level 47 -50 84 - 90 8.4 - 9.0 58 - 63 10 43 - 46 76 - 83 7.6 - 8.3 53 - 57 9 37 - 42 65 - 75 6.5 - 7.5 46 - 52 8 29 - 36 51 - 64 5.1 - 6.4 36 - 45 7 23 - 28 40 - 50 4.0 - 5.0 28 - 35 6 19 - 22 33 - 39 3.3 - 3.9 23 - 27 5 1) 15 - 18 26 - 32 2.6 - 3.2 18 - 22 4 11 - 14 19 - 25 1.9 - 2.
• Release • Press when and . Indicators of the indicator start to flash. , and flash. The current setting is indicated by the intermittent flashing : e.g. 5 intermittent flashes + pause + 5 intermittent flashes = level 5. • Press to change the setting. Each time you press the button, the level increases. After level 10 you will start again from level 1. • Turn the knob to to confirm the setting. ADDING SALT Before first use put one litre of water in the salt container.
ADDING DETERGENT 1 A B 30 20 2 If the programme has a prewash phase, put a small quantity of detergent also in compartment B. ADDING MULTI-TABLETS 1 30 20 2 • • • Do not fill the salt container and the rinse aid dispenser. Adjust the water softener to the lowest level. Set the rinse aid dispenser to the lowest position. PROGRAMME SELECTION MODE The appliance must be in Programme selection mode to start a programme. If the control panel does not show this condition, do the Reset.
STARTING A PROGRAMME Open the water tap, close the door, select a programme, press Start . OPTION DELAY With this option you can postpone the start of a programme of 3 hours. Set the programme, press Delay. Press Start to start the countdown. At the end of the countdown, the programme starts. OPENING THE DOOR WHILE THE APPLIANCE OPERATES If you open the door while a programme is running, the appliance stops. When you close the door, the appliance continues from the point of interruption.
AT THE END OF THE PROGRAMME 5 min The indicator comes on. If you do not deactivate the appliance within 5 minutes all indicators goes off. This helps to decrease energy consumption. Turn the knob to . Close the tap. HINTS AND TIPS GENERAL The following hints will ensure optimal cleaning and drying results in daily use and also help to protect the environment. • Remove larger residues of food from the dishes into the waste bin. • Do not pre-rinse dishes by hand.
• • Detergent tablets do not fully dissolve with short programmes. To prevent detergent residues on the tableware, we recommend that you use the tablets with long programmes. Do not use more than the correct quantity of detergent. Refer to the instructions on the detergent packaging. WHAT TO DO IF YOU WANT TO STOP USING MULTI-TABLETS Before you start to use separately detergent, salt and rinse aid do the following procedure. 1. Set the highest level of the water softener. 2.
CLEANING THE FILTERS B A C • • • • Make sure that there are no residues of food or soil in or around the edge of the sump. Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides. Reassemble the filters (A) and (B). Put back the filter (A) in the flat filter (C). Turn it clockwise until it locks. An incorrect position of the filters can cause bad washing results and damage to the appliance CLEANING THE SPRAY ARMS Do not remove the spray arms.
The majority of problems that can occur can be solved without the need to contact an Authorised Service Centre. Problem and alarm code You cannot activate the appliance. Possible cause and solution • • The programme does not start. • • • • The appliance does not fill with water. • The end indicator flashes 1 time intermittently. • The Start indicator flashes continuously. • • • • • Make sure that the appliance door is closed. Press Start.
Problem and alarm code Possible cause and solution Rattling/knocking sounds from inside the appliance. • The appliance trips the circuit-beaker. • • • The tableware is not properly arranged in the baskets. Refer to basket loading leaflet. Make sure that the spray arms can rotate freely. The amperage is insufficient to supply simultaneously all the appliances in use. Check the socket amperage and the capacity of the meter or turn off one of the appliances in use.
Problem Possible cause and solution The interior of the appliance is wet. • This is not a defect of the appliance. it is caused by the humidity in the air that condenses on the walls. Unusual foam during washing. • • Use the detergent for dishwashers only. There is a leak in the rinse aid dispenser. Contact an Authorised Service Centre. Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softener".
Power consumption Off-mode (W) 0.50 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. RATING PLATE Mod. ... ... ... Prod. No. ... ... ... Ser. No. ... CH INFORMATION FOR TEST INSTITUTES For all the necessary information for test performance, send an email to: info.test@dishwasher-production.
appliances. Do not dispose appliances marked with For Switzerland: Where should you take your old equipment? Anywhere that sells new equipment or hand it in to official SENS collection points or official SENS recycling firms. The list of official SENS collection points can be found at www.erecycling.ch the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
100002471-A-172015 WWW.ZANUSSI.