User manual

Make sure that the water inlet hose, the drain hose and the
supply cable are not kinked or squashed, when you insert
the machine.
Attaching the appliance to the adjacent units
Make sure that the counter below which you attach the ap-
pliance is a safe structure (adjacent kitchen units, cabi-
nets, wall).
Adjusting the level of the appliance
Make sure that the appliance is level to close and seal the
door correctly. If the level of the appliance is correct, the
door does not catch on the sides of the cabinet. If the door
does not close correctly, loosen or tighten the adjustable
feet until the appliance is level.
Water connection
Water inlet hose
Connected the appliance to a hot (max. 60°) or cold water
supply.
If the hot water comes from alternative sources of energy
that are more environmentally friendly (e.g. solar or pho-
tovoltaic panels and aeolian), use a hot water supply to
decrease energy consumption.
Connect the inlet hose to a water tap with an external
thread of 3/4”.
Caution! Do not use connection hoses from an old
appliance.
The water pressure must be in the limits (refer to the
chapter 'Technical data'). Make sure that the local water
authority gives you the average mains pressure in your
area.
Make sure that there are no kinks in the water inlet hose
and that the water inlet hose is not squashed or entangled.
Turn the inlet hose to the left or the right to suit the instal-
lation. Fit the locknut correctly to prevent water leaks.
Caution! Do not connect the appliance to new pipes
or pipes that are not used for a long time. Let the
water run for some minutes, then connect the inlet hose.
Water inlet hose with safety valve
The water inlet hose is a double-walled and has an inner
mains cable and a safety valve. The water inlet hose is un-
der pressure only while the water is running. If there is a
leak in the water inlet hose, the safety valve interrupts the
running water.
Warning! Dangerous
voltage
Be careful when you connect the water inlet hose:
• Do not put the water inlet hose or the safety valve in
water.
• If the water inlet hose or the safety valve is damaged,
immediately disconnect the mains plug from the mains
socket.
• Only let the Service Force Centre replace the water inlet
hose with safety valve.
Drain hose
1
Connect the water drain
hose to the sink spigot.
max 85 cm
min 40 cm
max 400 cm
2
30