User manual Dishwasher ZDF 311
Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance.
Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
Installation • Check your dishwasher for any transport damage. Never connect a damaged machine. If your dishwasher is damaged contact your supplier. • All packaging must be removed before use. • Any electrical and plumbing work required to install this appliance must be carried out by a qualified and competent person. • For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way.
Control panel 1 2 3 4 5 On/Off button Programme selection buttons Delay start button Indicator lights Function buttons Setting mode IMPORTANT! Always remember that when performing operations as: – selecting a washing programme, – setting the water softener, the appliance MUST be in setting mode: • Press On/Off button, ALL programme selection button lights are illuminated = appliance in setting mode. • Press On/Off button, ONLY a programme button light is illuminated = last performed programme still set.
Function buttons In addition to the dishwashing programme selection, the following functions can also be set with the help of these buttons. – the setting of the water softener, – the cancelling of a programme in progress. Programme selection buttons • Starting the washing programme: 1. Press the On/Off button. 2. Press the button corresponding to the required programme, the corresponding light remains illuminated while the other programme lights turn off. 3.
Delay start button This option allows the start of the programme to be delayed by 3 or 6 hours. Before selecting the washing programme, press the On/Off button and then press the delay start button until the light corresponding to 3h or 6h illuminates. Press the button corresponding to the required washing programme, the countdown will start automatically after about 3 seconds. Once the countdown has elapsed the washing programme will start automatically. The delay start light will turn off.
Indicator lights Illuminates when rinse aid needs to be filled. Rinse aid 2) 1) As soon as you select a washing programme, the phase indicator lights for that programme will start flashing. As the programme starts, the phase indicator lights turn off except for the indicator light of the phase in progress which will remain lit with a static light. 2) The salt and rinse aid indicator lights are never illuminated while a washing programme is running even if filling with salt and rinse aid is necessary.
Programme Rinse and Hold Degree of soil Type of load Any. Partial load (to be completed later in the day). Programme description 1 cold rinse (to avoid food scraps from sticking together). This programme does not require the use of detergent. 1) Ideal for washing a partially loaded dishwasher. This is perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. 2) Test programme for test institutes.
Water hardness °dH °TH Adjusting the water hardness setting mmol/l manually Use of salt electronically 51 - 70 91 - 125 9,1 - 12,5 2 level 10 yes 43 - 50 76 - 90 7,6 - 8,9 2 level 9 yes 37 - 42 65 - 75 6,51 - 7,5 2 level 8 yes 29 - 36 51 - 64 5,1 - 6,4 2 level 7 yes 23 - 28 40 - 50 4,0 - 5,0 2 level 6 yes 19 - 22 33 - 39 3,3 - 3,9 2 level 5 yes 15 - 18 26 - 32 2,61 - 3,2 1 level 4 yes 11 - 14 19 - 25 1,9 - 2,5 1 level 3 yes 4 - 10 7 - 18 0,71 - 1,8 1
• The dishwasher must be switched off. Switch on the dishwasher by pressing the On/Off button. • Press and hold simultaneously function buttons B and C until the lights of function buttons A , B and C start flashing. • Release the buttons and then press function button A; the lights of function buttons B and C turn off while function button A goes on flashing. At the same time End of programme light starts to flash. The number of flashes of the End of programme light corresponds to the current level.
IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT! Top up the special salt when the light on the control panel illuminates. Filling with rinse aid Open the lid. CAUTION! Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance.
Adjusting the dosage of rinse aid Increase the dose if there are drops of water or lime spots on the dishes after washing. Open the lid. Reduce the dose if there are whitish streaks on the dishes or a bluish film on glassware or knife blades. Set the dosage level. (The dose is factory set in position 4). Close the lid and press until it locks. Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher.
For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, china or mother-ofpearls handles. • Plastic items that are not heat resistant. • Older cutlery with glued parts that are not temperature resistant. • Bonded cutlery items or dishes. • Pewter or copper items. • Lead crystal glass. • Steel items prone to rusting. • Wooden platters. • Items made from synthetics fibres.
The two rows of prongs on the lower basket can be easily lowered to allow you to load pots, pans and bowls. Load upper basket. Light items (plastic bowls etc.) must be loaded in the upper basket and arranged so they do not move. For taller items, the cup racks can be folded upwards. If plates are to be loaded in the upper basket: load them starting from the rear positions; tilting them slightly forwards and avoiding the front positions near the door.
To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. To lower the basket to the original position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards and then allow the mechanism to drop back down slowly, keeping hold of it.
For programmes with prewash add an additional detergent dose in compartmentB. When using detergent tablets: place detergent tablets in compartment A. Close the lid. "3 in 1 function" This appliance is equipped with the "3 in 1 function", that allows the use of the "3 in 1" combi detergent tablets. These products are detergents with a combined cleaning, rinsing and salt functions. They can also contain other different agents depending on which kind of tablets you choose ("3 in 1", "4 in 1", "5 in 1" etc.
function "indicator light illuminates. This means that the function is active. To deactivate the function press the same buttons again until the indicator light corresponding to the "3 in 1" symbol turns off. IMPORTANT! If the drying results are not satisfactory we suggest that you: 1. 2. 3. • Fill up the rinse aid dispenser with rinse aid. Activate the rinse aid dispenser. Set the rinse aid dosage to position 2.
Care and cleaning Cleaning the filters IMPORTANT! NEVER use the dishwasher without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Clean filters A, B and C thoroughly under running water. Put the flat filter A back in the base of the washing compartment and ensure that it fits perfectly under the two guidesD. Turn the handle about 1/4 turn anticlockwise and remove filters B and C. Remove filter A from the base of the washing compartment.
abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run the wash programme for heavy soiled dishes using detergent but without dishes. Prolonged periods of nonoperation If you are not using the machine for any prolonged period of time you are advised to: 1. Unplug the appliance and then turn off the water. 2.
caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. Something not working The dishwasher will not start or stops during operation. Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.
Fault code and malfunction • The programme does not start. Once these checks have been carried out; close the dishwasher s door and switch on the appliance. Press the button of the programme that was running before the intervention of the alarm. The programme will continue from the point at which it was interrupted. If the malfunction or fault code reappears contact the Service Force Centre. For other fault codes not described in the above chart, please contact your Service Force Centre.
The wash results are not satisfactory The dishes are wet and dull • Rinse aid was not used. • The rinse aid dispenser is empty. There are streaks, milky spots or a bluish coating on glasses and dishes • Decrease rinse aid dosing. Water drops have dries onto glasses and dishes • Increase rinse aid dosing. • The detergent may be the cause. Contact the detergent manufacturer s consumer care line. If after all these checks, the problem persists, contact your local Service Force Centre.
Consumption values Programme Programme duration (in minutes) Energy consumption (in kWh) Water (litres) Eat-Load-Run 30 0,9 9 BIO 50° (Test programme for Test Institutes) 170 1,05 16 Rinse and Hold 12 0,1 4 Hints for test institutes Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Consumption values").
cup racks: position A Installation WARNING! Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. (max. 60°) or cold water. Nevertheless we advise you a cold water supply. Water connection CAUTION! If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose.
Drain hose Connect drain hose to the sink. Secure it with the supplied hose clamp. Required height: 30 to 100 cm above bottom of the dishwasher. If you use a drain hose extension the total length should not be longer than 4 metres. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. Electrical connection CAUTION! Safety standards require the appliance to be earthed.
Fitting under a counter By removing the dishwasher s worktop, you can install it under a close fitting sink unit or a pre-existing top. Be sure that once the appliance has been installed, it is easily accessible for the service engineer in the event that a repair is required. Levelling Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on either side of the cabinet.
2. 3. 4. 5. 6. 7. 8. 28 livered to the first end user. These guarantee terms do not apply in the event of use for professional or equivalent purposes. Performing the guarantee means that the appliance is returned to the condition it was in before the defect occurred. Defective parts are replaced or repaired. Parts replaced free of charge become our property. So as to avoid more severe damage, the defect must be brought to our attention immediately.
15. Except in the event where liability is legally imposed, this declaration of guarantee terms excludes any compensation for damage outside the appliance for which the consumer wishes to assert his rights. In the event of legally admitted liability, compensation will not exceed the purchase price paid for the appliance. These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e.g.
• The appliance guarantee is for the same period and to the same extent for labour and parts as exists in your new country of residence for this particular model or range of appliances. • The appliance guarantee is personal to the original purchaser of the appliance and cannot be transferred to another user. • The appliance is installed and used in accordance with instructions issued by Elec- trolux and is only used within the home, i.e. is not used for commercial purposes.
Lietuva +370 5 2780609 Ozo 10A, LT 08200 Vilnius Luxembourg +352 42 431 301 Rue de Bitbourg, 7, L-1273 Hamm Magyarország +36 1 252 1773 H-1142 Budapest XIV, Erzsébet királyné útja 87 Nederland +31 17 24 68 300 Vennootsweg 1, 2404 CG - Alphen aan den Rijn Norge +47 81 5 30 222 Risløkkvn. 2 , 0508 Oslo Österreich +43 18 66 400 Herziggasse 9, 1230 Wien Polska +48 22 43 47 300 ul.
www.electrolux.
