Operation Manual

ManualsBrandsZanussi ManualsDomestic AppliancesZDF14011XA

Internal cleaning

If you regularly use short duration pro-

grammes, these can leave deposits of grease

and limescale inside the appliance.

To prevent this, we recommend to run long

duration programmes at least 2 times per

month.

Troubleshooting

The appliance does not start or it stops during

operation.

Before you contact the Service, refer to the in-

formation that follows for a solution to the

problem.

With some problems, the display shows

an alarm code:

•

- The appliance does not fill with water.

•

- The appliance does not drain the wa-

ter.

•

- The anti-flood device is on.

Warning! Deactivate the appliance

before you do the checks.

Problem Possible solution

You cannot activate the appliance. Make sure that the mains plug is connected to the mains

socket.

Make sure that there is not a damaged fuse in the fuse box.

The programme does not start. Make sure that the appliance door is closed.

If the delay start is set, cancel the setting or wait for the end

of the countdown.

The appliance does not fill with water. Make sure that the water tap is open.

Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authority.

Make sure that the water tap is not clogged.

Make sure that the filter in the inlet hose is not clogged.

Make sure that the inlet hose has no kinks or bends.

The appliance does not drain the water. Make sure that the sink spigot is not clogged.

Make sure that the drain hose has no kinks or bends.

The anti-flood device is on. Close the water tap and contact the Service.

After the checks are completed, activate the

appliance. The programme continues from the

point of interruption.

If the problem occurs again, contact the Serv-

ice.

If the display shows other alarm codes, con-

tact the Service.

If the washing and drying results are not

satisfactory

Whitish streaks or bluish layers on

glasses and dishes

• The released quantity of rinse aid is too

much. Adjust the rinse aid selector to a low-

er position.

• The quantity of detergent is too much.