Operation Manual

3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the appli-
ance. Start a programme to remove them.
Do not use detergent and do not load the
baskets.
Adjusting the water softener
Water hardness
Water softener
adjustment
German
degrees
(°dH)
French
degrees
(°fH)
mmol/l Clarke
degrees
Level
47 - 50 84 - 90 8.4. - 9.0 58 - 63 10
43 - 46 76 - 83 7.6 - 8.3 53 - 57 9
37 - 42 65 - 75 6.5 - 7.5 46 - 52 8
29 - 36 51 - 64 5.1 - 6.4 36 - 45 7
23 - 28 40 - 50 4.0 - 5.0 28 - 35 6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
5
1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 2
< 4 < 7 < 0.7 < 5
1
2)
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in
setting mode, refer to “Setting and starting
a programme”.
2. Press and hold, at the same time,
and until the indicators of
, and start to flash.
3.
Press
.
•
The indicators of
and go
off.
•
The indicator of
continues to
flash.
• The display shows the current setting of
the water softener, e.g.
= level 5.
4.
Press
again and again to change
the setting. Each time you press the button
you select the next level.
5. Deactivate the appliance to confirm the
setting.
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent it, after you fill
the salt container, start a programme.
1
2
55
www.zanussi.com