User manual Dishwasher ZDF 511
Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance.
Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
Installation • Check your dishwasher for any transport damage. Never connect a damaged machine. If your dishwasher is damaged contact your supplier. • All packaging must be removed before use. • Any electrical and plumbing work required to install this appliance must be carried out by a qualified and competent person. • For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way.
Control panel 1 2 3 4 5 6 On/Off button Programme selection buttons Delay start button Indicator lights Digital display Function buttons Setting mode IMPORTANT! Always remember that when performing operations as: – selecting a washing programme, – setting the water softener, – activating/deactivating the rinse aid dispenser the appliance MUST be in setting mode: • Press On/Off button, ALL programme selection button lights are illuminated = appliance in setting mode.
In this case the programme has to be cancelled (see instructions “Cancel a washing programme in progress”). Function buttons In addition to the dishwashing programme selection, the following functions can also be set with the help of these buttons. – the setting of the water softener, – the cancelling of a programme in progress.
Programme selection buttons • Starting the washing programme: 1. Press the On/Off button. 2. Press the button corresponding to the required programme, the corresponding light remains illuminated while the other programme lights turn off. In the digital display will appear, flashing, the running time of the programme (in minutes). 3. The programme in progress light illuminates. 4. Close the dishwasher’s door, the programme will start automatically.
This option allows the start of the programme to be delayed from 1 to 19 hours. After having selected the washing programme press the delay start button until the flashing number of the hours for the delay start will appear in the digital display. Close the dishwasher’s door, the countdown starts automatically. Once the countdown has elapsed the washing programme will start automatically.
Washing programmes Programme Degree of soil Type of load Programme description Intensive 70° Heavy soil Crockery, cutlery, pots and pans Prewash Main wash 2 intermediate rinses Final rinse Drying AUTO 65° 50° Normal / Light soil. Crockery and cutlery Prewash Main wash 1 or 2 intermediate rinses Final rinse Drying Eat-Load-Run Light soil Crockery and cutlery Main wash Final rinse Normal soil Crockery and cutlery Prewash Main wash 1 intermediate rinse Final rinse Drying 1) 30 min.
During the "Auto" programme the temperature of the main wash water is also automatically adjusted between 50°C and 65°C depending on the amount of soil on the dishes. For this reason the programme duration, water and energy consumption levels can vary within the stated range for "Auto" programme (see "Washing programmes chart").
Water hardness Clarke °TH Adjusting the water hardness setting mmol/l manually Use of salt electronically 23 - 27 33 - 39 3,3 - 3,9 2 level 5 yes 18 - 22 26 - 32 2,61 - 3,2 1 level 4 yes 13 - 17 19 - 25 1,9 - 2,5 1 level 3 yes 5 - 12 7 - 18 0,71 - 1,8 1 level 2 yes <5 <7 < 0,7 1 level 1 no The water softener must be set in both ways: manually, using the water hardness dial and electronically.
1. Press the On/Off button. The dishwasher must be in setting mode. 2. Simultaneously press and hold function buttons B and C, until the lights of function buttons A, B and C start flashing. 3. Press function button A, the lights of function buttons B and C turn off while the light of function button A goes on flashing. In the digital display is visible the current level. Examples: displayed = level 5 displayed = level 10 4. To change the level, press function button A.
IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT! Top up the special salt when the light on the control panel illuminates. Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close the lid and press until it indicated by "max" locks.
Adjusting the dosage of rinse aid Increase the dose if there are drops of water or lime spots on the dishes after washing. Open the lid. Reduce the dose if there are whitish streaks on the dishes or a bluish film on glassware or knife blades. Set the dosage level. (The Close the lid and press undose is factory set in po- til it locks. sition 4). Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher.
For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, china or mother-ofpearls handles. • Plastic items that are not heat resistant. • Older cutlery with glued parts that are not temperature resistant. • Bonded cutlery items or dishes. • Pewter or copper items. • Lead crystal glass. • Steel items prone to rusting. • Wooden platters. • Items made from synthetics fibres.
The two rows of prongs on the lower basket can be easily lowered to allow you to load pots, pans and bowls. Load upper basket. Light items (plastic bowls etc.) must be loaded in the upper basket and arranged so they do not move. For taller items, the cup racks can be folded upwards. If plates are to be loaded in the upper basket: load them starting from the rear positions; tilting them slightly forwards and avoiding the front positions near the door.
To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. To lower the basket to the original position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards and then allow the mechanism to drop back down slowly, keeping hold of it.
For programmes with pre- When using detergent Close the lid. wash add an additional tablets: place detergent detergent dose in comtablets in compartment A. partmentB. "3 in 1 function" This appliance is equipped with the "3 in 1 function", that allows the use of the "3 in 1" combi detergent tablets. These products are detergents with a combined cleaning, rinsing and salt functions. They can also contain other different agents depending on which kind of tablets you choose ("3 in 1", "4 in 1", "5 in 1" etc.
function "indicator light illuminates. This means that the function is active. To deactivate the function press the same buttons again until the indicator light corresponding to the "3 in 1" symbol turns off. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. 2. Activate the rinse aid dispenser. 3. Set the rinse aid dosage to position 2.
Care and cleaning Cleaning the filters IMPORTANT! NEVER use the dishwasher without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing comwater. move filters B and C. partment.
Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run the wash programme for heavy soiled dishes using detergent but without dishes. Prolonged periods of nonoperation If you are not using the machine for any prolonged period of time you are advised to: 1. Unplug the appliance and then turn off the water. 2. Leave the door ajar to prevent the formation of any unpleasant smells. 3.
correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. Something not working The dishwasher will not start or stops during operation.
Fault code and malfunction The programme does not start. Once these checks have been carried out; close the dishwasher’s door and switch on the appliance. Press the button of the programme that was running before the intervention of the alarm. The programme will continue from the point at which it was interrupted. If the malfunction or fault code reappears contact the Service Force Centre. For other fault codes not described in the above chart, please contact your Service Force Centre.
The wash results are not satisfactory The dishes are not clean • The wrong washing programme has been selected. • The dishes are arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. • The spray arms do not rotate freely due to incorrect arrangement of the load. • The filters in the base of the washing compartment are dirty or incorrectly positioned. • Too little or no detergent has been used.
Noise level dB(A) 47 Consumption values iations of the power supply and the amount of dishes. The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the var- Consumption values Programme Programme duration (in Energy consumption (in minutes) kWh) Water (litres) Intensive 70° * 1,6-1,8 22-24 AUTO 50° 65° * 1,1-1,6 12-23 Eat-Load-Run 30 min.
Full load: 12 standard place settings Rinse aid setting Upper basket position 4 (Type III) Cutlery basket Lower basket cup racks: position A Installation WARNING! Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Water connection WARNING! The dishwasher must not be connected to open water appliances or instantaneous water heaters. This dishwasher may be fed with either hot 26 (max.
Inlet hose Connect the inlet hose to a water tap with an external thread of 3/4”. The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks. Drain hose Connect drain hose to the Required height: 30 to 100 Ensure that the hoses are When connecting the sink. Secure it with the cm above bottom of the not kinked, crushed or en- drain hose to an under supplied hose clamp. dishwasher. tangled.
Electrical connection CAUTION! Safety standards require the appliance to be earthed. Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed. The fuse rating is also to be found on the rating plate. Always plug the mains plug into a correctly installed shockproof socket. Multi-way plugs, connectors and extension cables must not be used.
Guarantee conditions Guarantee/Customer Service Standard guarantee conditions We, Zanussi-Electrolux , undertake that if within 12 months of the date of the purchase this Zanussi-Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: • The appliance has been correctly installed and used only on the electricity supply stated on th
address below or visit our website at www.electrolux.co.uk Customer Care Department Electrolux Major Appliances Addington Way Luton Bedfordshire, LU4 9QQ Tel: 08705 727 727 (*) (*) Calls may be recorded for training purposes European Guarantee This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law.
Great Britain +44 8705 929 929 Addington Way, Luton, Bedfordshire LU4 9QQ Hellas +30 23 10 56 19 70 4, Limnou Str., 54627 Thessaloniki Hrvatska +385 1 63 23 338 Slavonska avenija 3, 10000 Zagreb Ireland +353 1 40 90 753 Long Mile Road Dublin 12 Italia +39 (0) 434 558500 C.so Lino Zanussi, 26 - 33080 Porcia (PN) Latvija +37 17 84 59 34 Kr.
Россия 32 +7 495 937 7837 129090 Москва, Олимпийский проспект, 16, БЦ "Олимпик"
www.electrolux.com www.zanussi-electrolux.co.