User manual

22
INSTALLATION
Electrical connection
The electrical connection must be carried out in
accordance with the current standards and laws in
force.
Before connecting check that:
• the system and electrical sockets amperage is
adequate for the appliance maximum power (see
data label affi xed on the back of the cooker).
• the socket or system has an effective earth
connection in accordance with current standards
and prescriptions of the law. All responsibility is
disclaimed if this is not complied with.
• The plug and socket or the multipolar switch must
be accessible after installation of the appliance.
When connecting to the mains with a socket:
• Fit to the power cable (if without) a standardized
plug, suitable for the load which is indicated on
the data label. Connect the wires making sure they
correspond as shown below, and remember that
the earth wire must be longer than the phase
wires:
letter L (phase) = brown wire
letter N (neutral) = blue wire
symbol
(earth)
= green/yellow wire
• The power cable must be laid so that no parts of it
ever reach a temperature of 75 °C.
• For connecting do not use, adapters or shunts
as they could cause false contacts resulting in
hazardous overheating.
When connecting directly to the mains:
• Install a multipolar switch that can withstand the
appliance load, with a minimum opening between
the contacts of 3 mm.
• Remember that the earth wire must not be cut out
by the switch.
Changing the fl exible gas hose
In order to guarantee that the gas hose is always in
excellent condition we strongly recommend changing it
on the date you will fi nd printed on it.
Replacing the electrical components
• The rear protection will have to be removed in
order to change the electrical heating elements,
spit motor, terminal board and power cable.
• If you have to change the power cable
(see the cross section in the table in the
“TECHNICAL FEATURES” section), always
keep the earth wire longer than the
phase wires and, in addition, follow all
the instructions given in the “Electrical
connection” paragraph.
• To replace the oven lamp please refer to
instructions on “Replacing the oven lamp”
paragraph.
• To change the lamp holder, the spark generator
and the spark electrodes, the work top has to be
removed as indicated in paragraph “Replacing
the taps and thermostat”.
• To change the eventual programming accessory,
the commutator and the indicator lights, remove
the front panel as indicated in paragraph “Taps”.