User manual

21
INSTALLATION
Maintenance
Prior to any maintenance work or changing
parts, disconnect the appliance from the gas and
electricity power sources.
Replacing the taps and thermostat
Proceed in the following way when replacing a tap or the
thermostat:
• Remove pan supports, burner heads.
• Unscrew the burner fi xing screws (Vc) (fi g. 26).
(four for ultrarapid burner and two for the other
burners)
• Remove the hob, unscrewing frontal and rear fi xing
screws (Vp,Vf,Vd) (fi g. 26) which lock the hob .
• Pull out the knobs.
• Unscrew the nuts (D) of the gas aluminium pipes
and pull out the thermocouple quick connectors (F)
(fi g. 28).
• Unscrew the screws (Vt) (fi g. 27) which lock the
crosspieces.
• Unscrew the screws (Vb) (fi g. 27) which unite the
the bridles of the taps to the front frame.
• Make to slip the ramp toward the back part and
unscrew the screws (Vb) (fi g. 28) in order to free
the taps.
• Change seal each time a tap or a thermostat
is replaced. This will ensure perfect retention
between the tap or a thermostat and part.
• Reassemble all the parts following the same
procedure but in the reverse order.
Vt
Vt
Vb
Fig. 27
D
F
Vb
Fig. 28
Vd
Vf
Vp
Vc
Fig. 26