EN User Manual Cooker ZCG62386 ZCG62396 EG
Contents Safety information Safety instructions Product description Before first use Hob - Daily use Hob - Hints and tips Hob - Care and cleaning 2 3 6 8 8 9 10 Oven - Daily use Oven - Clock functions Oven - Using the accessories Oven - Hints and tips Oven - Care and cleaning Troubleshooting Installation 10 12 12 14 17 18 20 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
• • • • • • • • • • • Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. Do not store items on the cooking surfaces. Do not use a steam cleaner to clean the appliance. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Remove any spillage from the lid before opening.
Electrical Connection appliance according to current installation regulations. Pay attention to requirements regarding adequate ventilation. WARNING! Risk of fire and electrical shock. • • • • • • • • • • • • • All electrical connections should be made by a qualified electrician. The appliance must be earthed. Make sure that the electrical information on the rating plate agrees with the power supply. If not, contact an electrician. Always use a correctly installed shockproof socket.
• • • • • • • • • • • • • • – do not keep moist dishes and food in the appliance after you finish the cooking. – be careful when you remove or install the accessories. Discoloration of the enamel has no effect on the performance of the appliance. It is not a defect in the sense of the warranty law. Use a deep pan for moist cakes. Fruit juices cause stains that can be permanent. Do not keep hot cookware on the control panel. Do not let cookware boil dry.
Disposal • • WARNING! Risk of injury or suffocation. • • Contact your municipal authority for information on how to discard the appliance correctly. Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. Remove the door catch to prevent children and pets to get closed in the appliance. Flat the external gas pipes. Service • • To repair the appliance contact an Authorised Service Centre. Use original spare parts only.
General overview 1 2 3 4 5 6 11 7 8 5 4 3 2 1 9 10 1 2 3 4 5 6 7 8 9 10 11 Button for the turnspit Electronic programmer Knob for the grill Knob for the oven functions Button for the lamp Knobs for the hob Grill Lamp Turnspit hole Fan Shelf positions Cooking surface layout 1 2 5 3 1 Auxiliary burner 2 Steam outlet - number and position depend on the model 3 Semi-rapid burner 4 Semi-rapid burner 5 Triple Crown burner 4 Accessories • • • • Wire shelf For cookware, cake tins, roasts.
Before first use WARNING! Initial Cleaning 2. Press the or button to set the time of day. After approximately five seconds, the flashing stops and the display shows the time you set. Remove all accessories from the appliance. Preheating Refer to Safety chapters. Refer to "Care and cleaning" chapter. Clean the appliance before first use. Put the accessories back to their initial position. Setting the time Preheat the empty appliance to burn off the remaining grease. 1. Set the maximum temperature. 2.
If the burner accidentally goes out, turn the knob to the off position and try to light the burner again after minimum 1 minute. A Burner overview B C A D B C D A) B) C) D) Burner cap Burner crown Ignition candle (if applicable) Thermocouple (if applicable) Turning the burner off To put the flame out, turn the knob to the off position . WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. Hob - Hints and tips WARNING! Refer to Safety chapters.
Energy saving Burner Diameter of cookware (mm) Semi-rapid 140 - 240 Auxiliary 120 - 180 • • If it is possible, always put the lids on the cookware. When the liquid starts to boil, turn down the flame to barely simmer the liquid. Hob - Care and cleaning WARNING! Refer to Safety chapters. General information • • • • • Clean the hob after each use. Always use cookware with clean bottom. Scratches or dark stains on the surface have no effect on how the hob operates.
Oven Functions Oven function 1-8 1-8 Application Off position The appliance is off. Heat settings Range of temperature levels adjustment for the oven.1) Grilling To grill flat food in the middle of the grill. To make toast. Oven fan To thaw frozen food. To use the fan in combination with the gas oven burner ignite the gas oven and turn the knob for the grill clockwise to activate the fan. Oven lamp To illuminate the oven interior. To use this function, press the button for the lamp.
Do not keep the knob for the oven functions pushed for more than 15 seconds. If the oven burner does not light after 15 seconds, release the knob for the oven functions, turn it into off position, open the oven door and try to light the oven burner again after minimum 1 minute. After igniting the oven gas burner 1. Release the knob for the oven functions. 2. Close the oven door. 3. Turn the knob for the oven functions to set the necessary heat setting.
A B C D Put the shelf on the correct shelf position. Make sure it does not touch the back wall of the oven. Tray: Do not push the baking tray all the way to the back wall of the cavity. This prevents the heat from circulating around the tray. The food may be burnt, especially in the rear part of the tray. A) B) C) D) Support hook Forks Spit Handle The support hook is installed in the top of the oven cavity. You can leave the support hook in the oven, when the turnspit is not active. 1. 2. 3. 4.
6. Use the screws to tighten the forks. 7. Put the tip of the spit into the turnspit hole. Refer to "Product description" chapter. 8. Put the front part of the spit on the support hook. 9. Remove the turnspit handle. 10. Light the grill. Refer to "Oven - Daily use" chapter. 11. Press the turnspit button . 12. Make sure that turnspit rotates. 13. Close the oven door. The turnspit does not stop if you open the oven door. When meat is ready press the turnspit button. Turn off the grill.
• If you use two baking trays at the same time, keep one empty level between them. condensation, add water each time after it dries up. Cooking meat and fish Cooking times • Cooking times depend on the type of food, its consistency, and volume. Use a deep pan for very fatty food to prevent the oven from stains that can be permanent. Leave the meat for approximately 15 minutes before carving so that the juice does not seep out.
Fish Food Quantity (kg) Thermostat position Time (min) Shelf position Pike 0.8 - 1.5 4 60 - 80 2 Dorade 0.4 - 0.7 4 40 - 60 2 Trout 0.5 - 1.0 4 25 - 30 2 Pizza Food Thin Quantity (kg) Thermostat position Time (min) Shelf position 1.0 - 1.2 8 20 - 30 1 1.4 - 1.5 8 25 - 30 1 1.4 - 1.5 6 30 - 35 1 1) Thick 1) Calzone 1) 1) Preheat the oven for 10 minutes. Cakes Food Flat cake Quantity (kg) Thermostat position Time (min) Shelf position 0.6 - 1.
Food Burgers Quantity (kg) Grill position Time (min) Shelf position 2.0 - 2.5 max. 15 - 20 3 1.2 - 1.5 half 20 - 25 3 0.5 - 0.8 max. 9 - 12 3 0.5 - 1.0 max. 15 - 20 3 1) Mackerel 1) Toast browning 1) Toast Hawai 1) 1) Preheat the oven for 5 minutes. Revolving frying Food Sheep on skewer Quantity (kg) Grill position Time (min) Shelf position 1.5 - 2.0 max. 100 - 120 Turnspit Chicken on skew- 1.2 - 1.8 er max.
3 2 2 2. Lift and turn the levers on the two hinges. 7. Clean the oven door with water and soap. Clean inner side of the door. Dry the oven door carefully. When the cleaning is completed, install the glass panels and the oven door. To install the oven door, do the above steps in the opposite sequence. 4 4 6 3. Close the oven door to the first opening position (halfway). Then pull forward and remove the door from its seat. 5 5 Replacing the lamp 4. Put the door on a soft cloth on a stable surface.
What to do if... Problem Possible cause Remedy There is no spark when you try to activate the spark generator. The hob is not connected to an electrical supply or it is connected incorrectly. Check if the hob is correctly connected to the electrical supply. Refer to the connection diagram. There is no spark when you try to activate the spark generator. The fuse is released. Make sure that the fuse is the cause of the malfunction. If the fuse releases again and again, contact a qualified electrician.
Problem Possible cause The display shows an error code that is not in this table. There is an electrical fault. Service data If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. Remedy Deactivate the oven with the house fuse or the safety switch in the fuse box and activate it again. If the display shows the error code again, contact the Customer Care Department. The necessary data for the service centre is on the rating plate.
Dimension Dimension mm D 20 Technical data Dimension mm Height mm Width 600 Depth 600 Appliance class 1 850 - 870 Other technical data Appliance category: II2H3B/P LPG: G30 (3B/P) 28-30 mbar Natural Gas: G20 (2H) 20 mbar Bypass diameters BURNER Ø BYPASS 1/100 mm Auxiliary 29 / 30 Semi-rapid 32 Triple Crown 67 Oven 50 Grill 59 Gas burners for NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW REDUCED POWER kW INJECTOR MARK 1/100 mm Triple Crown 4.0 1.
Gas burners for LPG G30 28-30 mbar BURNER NORMAL POWER kW REDUCED POWER kW INJECTOR MARK 1/100 mm Triple Crown 4.0 1.80 101 Semi-rapid 2.0 0.43 71 Auxiliary 1.0 0.35 50 Oven 2.25 1.0 71 Grill 2.0 1.5 71 Gas connection The gas pipe in the appliance has two endings. You can connect the gas supply to either one of them. The pipe that is not used must be clogged with the pipe closer, which added to the appliance.
If the appliance is set for liquid gas you can change it to natural gas, with the correct injectors. The gas rate is adjusted to suit. WARNING! Before you replace the injectors, make sure that the gas knobs are in the Off position. Disconnect the appliance from the electrical supply. Let the appliance cool down. There is a risk of injury. The appliance is set to default gas. To change the setting choose a pipe holder from the list. Always use the gasket sealing.
Oven injector replacement 1. Remove the bottom plate of the oven cavity to get access to the oven burner . 1 2 4. Release the burner injector with a 7 mm socket spanner and replace it with a right one. 2. Carefully remove from the burner the thermocouple A. Next remove the spark plug B. A B Assemble the burner in a revers sequence. 3. Unscrew the screw and slowly pull out the burner. Replace the gas type sticker near the gas supply ramp with the one related to the new gas type.
dismount the control panel before adjustment start. 3. With a thin and flat screwdriver adjust the bypass screw A. The model determines the position of the bypass screw A. Gas grill injector replacement 1. Release the screws which keep the grill burner in position A. A A Changing from natural gas to liquid gas 2. Release the burner injector with a 7 mm socket spanner and replace it with a right one. 1. Fully tighten the bypass screw. 2. Put the knob back. 3. Connect the appliance to the electricity.
3. If the floor is not equally flat, use the adjustable feet on the bottom of the appliance to set a stable position for the appliance. 2. Put the appliance on the sidewall on a clean and smooth surface. Place each foot into a separate hole, in the plinth, and rotate it counterclockwise. To install all the accessories, do the first step in an opposite sequence. Electrical installation WARNING! The manufacturer is not responsible if you do not follow the safety precautions from Safety chapters.
www.zanussi.
867306266-A-372014 www.zanussi.
