User manual

• For manual ignition put the flame near the
burner. Push the knob for the hob down and
turn it counterclockwise to the maximum gas
flow position .
Keep the knob for the hob pushed for equal or less
than 10 seconds to let the thermocouple warm up.
If not, the gas supply is interrupted.
Adjust the flame after it is regular.
WARNING! Do not keep the knob
pushed for more than 15 seconds. If
the burner does not light after 15
seconds, release the knob, turn it into
the off position and try to light the
burner again after minimum 1 minute.
If after some tries the burner does not
light, check if the crown and its cap
are in the correct position.
If the burner accidentally goes out,
turn the knob to the off position and try
to light the burner again after minimum
1 minute.
BURNER OVERVIEW
A
B
C
A. Burner cap
B. Burner crown
C. Thermocouple (if applicable)
TURNING THE BURNER OFF
To put the flame out, turn the knob to the off
position .
WARNING! Always turn the flame
down or switch it off before you
remove the pans from the burner.
HOB - HINTS AND TIPS
WARNING! Refer to Safety chapters.
COOKWARE
WARNING! Do not put the same pan
on two burners.
WARNING! Do not put unstable or
damaged pots on the burner to
prevent spills and injuries.
CAUTION! Make sure that pot
handles are not above the front edge
of the cooktop.
CAUTION! Make sure that the pots
are placed centrally on the burner in
order to get the maximum stability and
a lower gas consumption.
DIAMETERS OF COOKWARE
WARNING! Use cookware with
diameters applicable to the size of
burners.
Burner
Diameter of cookware
(mm)
Rapid 160 - 260
Semi-rapid 140 - 240
Auxiliary 120 - 180
ENERGY SAVING
• If it is possible, always put the lids on the
cookware.
• When the liquid starts to boil, turn down the
flame to barely simmer the liquid.
8