User manual

Changing from liquid gas to natural gas
1. Unscrew approximately one turn the bypass
screw position A.
2. Put the knob for the oven functions back.
3. Connect the appliance to the electricity.
WARNING! Put the mains plug
into the mains socket only if all
parts are back into their initial
position. There is a risk of injury.
4. Light the burner.
Refer to "Oven - Daily use" chapter.
5. Turn the knob for the oven functions on the
minimum position.
6. Remove the knob for the oven functions again.
7. Screw on slowly the bypass screw till the flame
becomes minimum and stable.
8. Put the knob for the oven functions back.
9. Set the maximum gas flow position on the knob
for the oven functions and let the oven heat for
at least 10 minutes.
10. Quickly turn the knob for the oven functions
from maximum to the minimum gas flow
position.
Control the flame. Make sure the flame does not go
out when you turn the knob to the minimum gas
flow position. There must be a small regular flame
on the oven burner crown. If the flame goes out
adjust the oven burner again.
GAS GRILL INJECTOR REPLACEMENT
1. Release the screws which keep the grill burner
in position A.
A
2. Release the burner injector with a 7 mm socket
spanner and replace it with a right one.
3. Assemble the burner in a reverse sequence.
Before you fix the screw, make sure that the
burner is pushed correctly to the back panel.
Test the grill injectors.
LEVELLING
CAUTION! Remove all the
accessories from the oven.
1. Open the lid of the appliance and disassemble
it.
2. Disassemble the pan supports and all the
burner assemblies.
3. Put the appliance on the sidewall on a clean
and smooth surface. Place each foot into a
separate hole, in the plinth, and rotate it
clockwise.
21