User manual

5. Use a screwdriver to remove 2 screws from
bottom edge of door.
1
1
6. Use a spatula made of wood or plastic or
equivalent to open the inner door. Hold the
outer door, and push the inner door against the
top edge of the door. Lift the inner door.
2
2
3
7. Clean the oven door with water and soap.
Clean inner side of the door. Dry the oven door
carefully.
When the cleaning is completed, install the glass
panels and the oven door. To install the oven door,
do the above steps in the opposite sequence.
4
4
5
5
6
REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem Possible cause Remedy
The flame extinguishes immedi-
ately after ignition.
Thermocouple is not heated up
sufficiently.
After lightning the flame, keep
the spark generator activated
for equal or less than 10 sec-
onds
15