User manual

13
Advice for safety
Gas connections
• Before installation ensure that the local
distribution conditions (gas type and pressure)
and the pre-setting of the appliance are
consistent.
• This appliance must be installed only in a room
with good ventilation.
• This appliance must not connected to a
chimney. It has to be installed and connected in
accordance with the rules in force. Special
attention should be paid to the applicable
disposal concerning ventilation.
• The adjacent furniture panels have to be heat
proof or protected by such material.
• The adjusting conditions of this appliance are
mentioned on the rating plate.
Connection to gas supply.
Check that the gas flow and the diameter of the
supply pipe is sufficient to supply all the appliances of
the installation.
• Check that all connections are tight.
• Install an accessible and visible gas tap to isolate
the appliance.
The manufacturing company declines any
responsibility for possible damages resulting
from an installation that doesn't comply with the
rules in force.
Electrical connections
This cooker is designed to be connected to a 230V
50Hz AC electrical supply.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the rating
plate.
Any electrical work required to install this
cooker should be carried out by a qualified
electrician or competent person, in
accordance with the current regulations.
This cooker must be earthed.
Check on the rating plate the value for the total
connection power for establishing the fuse power.
Fuse capacity: max 10 A
If the supply cable is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order
to avoid a hazard.
Before connecting check that:
The plug used for connection is easily accessible when
the appliance is installed.