Operation Manual

Replacing the gas oven burner injector:
B
C
1. Remove the bottom plate of the oven cavity to get
access to the gas oven burner.
2. Release the screw ( B ), which keep the gas oven
burner in position.
3. Carefully push the oven burner backwards.
4. Replace the nozzle ( C ) with a No.10 socket spanner.
5. Assemble the gas oven burner in opposite sequence.
6. Replace the gas type sticker near the gas supply ramp
with the one related to the new gas type.
Warning! A primary air adjustment of the gas oven
burner is not necessary.
Control the flame. If the flame goes out, do the procedure
from point 1 to point 5 again. There must be a small reg-
ular flame on the gas oven burner crown.
The manufacturer objects liability if you do not obey to
this safety measures.
Adjustment of minimum level
To adjust the minimum level of the burners:
1. Light the burner.
2. Turn the knob on the minimum position.
3. Remove the control knob.
4. With a thin screwdriver, adjust the by-pass screw
position. If you change from natural gas 20 mbar to
liquid gas, fully tighten the adjustment screw in. If
you change from liquid gas to natural gas 20 mbar,
undo the by-pass screw approximately 1/4 of a turn.
1 Minimum adjustment screw
5. Make sure the flame does not go out when you quickly
turn the knob from the maximum position to the min-
imum position.
Disposal
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please
contact your local council, your household waste disposal
service or the shop where you purchased the product.
Packaging material
The packaging material is environmentally-friendly
and recyclable. Plastic parts are marked with international
abbreviations such as PE, PS, etc. Dispose of the pack-
aging material in the containers provided for this purpose
at your local waste management facility.
Warning! Your appliance should be made
inoperable before it is disposed of, so that it does
not constitute a danger.
To do this, take the mains plug from the socket and remove
the mains cable from the appliance.
24
1