User manual

15
SAFETY ADVICE
• This cooker must be installed by qualified
electrician, according to the manufacturer's
instructions.
• Before your appliance is connected to the
mains electricity supply, check to ensure that
the voltage and the frecquency shown in the
rating label corresponds with your supply
voltage.
• This appliance has to be installed and
connected in accordance with the rules in
force.
• This appliance must only be installed by a
qualified electrician.
• To use supply cord type H05 RR-F.
LOCATION
The cooker has been registered as a “Class
X”appliance according to Fire Rick Regulations.
Any adjacent cabinets or walls must not exceed
the cooker’s height.
The cooker may be located in a kitchen, a
kitchen/diner or bed sitting room, but not in a
bathroom or shower room.
The minimum distance combustible material can
be fitted above the cooker in line with the edges
(see fig. 17).
Electrical connections
Any electrical work required to install
this cooker should be carried out by a
qualified electrician or competent person, in
accordance with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should these safety measures not be
observed.
This cooker is designed to be connected to a
230/400V, 50Hz electrical supply.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the rating plate.
The cooker is supplied with supply cord. A 3 core
flexible supply cord must be fitted, in accordance
with the specification gived in the relevant table
no. 1.
In case of a direct connection to the mains you
have to interpose an omnipolar switch a
minimum opening between contacts of 3 mm.
The switch should be sited within 2m of the hob
and be easily accessible upon completion of the
installation.
61 cm
min
min 15 cm
fig. 17