User manual

5
Ubicación estantes de la
contrapuerta
Para poder colocar confecciones de varios tamaños
es posible colocar los estantes de la contrapuerta a
varias alturas.
La operación se efectúa de la siguiente manera:
Empujar gradualmente el estante en el sentido
indicado por las flechas hasta llegar a
desengancharlo, luego volverlo a montar en la
posición deseada.
PR260
D040
Rejillas movibles
En las paredes del compartimento existen unas
guías que consienten poner las rejillas a distintas
alturas.
Refrigeracíon de alimentos y bebidas
Para utilizar de la mejor manera el compartimiento
refrigerante, es necesario:
• no introducir comidas calientes o líquidos en en
evaporacíon;
• tapar o envolver los alimentos, especialmente si
son aromáticos;
• no colocar sobre las rejillas papeles, cartones o
plásticos que obstaculicen la circulacíon del aire.
16
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Ensure that air can circulate freely around the back
of the cabinet. To ensure best performance, if the
appliance is positioned below an overhanging wall
unit, the minimum distance between the top of the
cabinet and the wall unit must be at least 100 mm
(A). Ideally, however, the appliance should not be
positioned below overhanging wall units (B).
Accurate levelling is ensured by one or more
adjustable feet at the base of the cabinet.
100 mm10 mm
10 mm
A
B
NP006
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation
Shelf holders
Your appliance is equipped with shelf retainers that
make it possible to secure the shelves during
transportation.
To remove them proceed as follows:
Raise the shelf from the back, push it in the direction
of the arrow until it is freed and remove the retainers.
A
B