User manual

10
CONTENTS
Warnings 9
Use 11
Cleaning the interior 11
Operation 11
Temperature regulation 11
Fresh food refrigeration 11
Movable shelves 11
Positioning the door shelves 11
Hints 12
Hints for refrigeration 12
Maintenance 12
Periodic cleaning 12
Periods of no operation 12
Interior light 12
Defrosting 13
Customer service and spare parts 13
Installation 14
Location 14
Electrical connection 14
Rear spacers 15
Changing the opening direction of the door 15
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials.The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities.The materials used on this appliance
marked by the symbol are recyclable.
Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
• Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
15
Changing the opening direction of
the door
Before buiding-in the appliance (if necessary),
change the opening direction of the door. To do this,
proceed as follows:
1. Remove the lower hinge (1) and feet (3)
2. Slide the door out from pin (G) and place it on the
opposite side;
3. Unscrew the foot front left and place it on the
opposite side;
4. Unscrew the two screws which mask the holes
for fixing the hinge on the front left side;
5. Reassemble the door
6. refit the lower hinge and feet (3) on the opposite
side;
7. dismantle the handle and reassemble it on the
opposite side.Cover the holes left open with the
plugs contained in the documentation pack.
Attention
After completion of the door reversibility
operation, verify that the door gasket is adherent
to the cabinet. If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
G
D715 PIED/C
1
3
D162/1
PR60
A
45°
Rear spacers
The plastic bag containing all relevant
documentation also contains two rear wall spacers
to be fitted into special slots on the back of the
appliance. Fit the spacers into the slots, taking care
to ensure that the arrow (A) is positioned as shown
in the figure. Next, turn them through 45° (arrow in
vertical position) until they lock into place.