MODE D'EMPLOI - HANDLEIDING GEBRAUCHSANLEITUNG - OPERATING INSTRUCTIONS CUISINIÈRE MIXTE GAS-EN ELEKTRISCH FORNUIS GAS-ELEKTROHERD ELECTROGAS COOKER ZC 605 M BE
ENGLISH IMPORTANT THE GUARANTEE This new appliance is easy to use, however, to obtain the best results, it is important to read this booklet and to follow all the instructions before using it for the first time. The booklet contains the necessary information regarding installation, use and maintenance, as well as giving useful advice. Your new cooker is covered by guarantee. You will find the guarantee certificate enclosed.
WARNINGS - GAS AND ELECTROGAS COOKERS It is very important that this instruction book should be kept safely for future consultation. If the appliance should be sold or given to another person, please ensure that the booklet goes together with it, so that the new owner can know of the functions of the machine and also be aware of the warnings. This warnings has been given for the safety of you and others. We therefore ask you to carefully read the procedures of installing and using this cooker.
CONTENTS Warning Instructions for the user Installation Use Electric Oven Programming Advice for use of oven Cooking times Maintenance Instructions for installation Gas connection Adaption to different types of gas Electrical connection What to do if... Technical Assistance and Spare Parts Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag.
INSTRUCTIONS FOR THE USER INSTALLATION IGNITION OF HOB BURNERS It is important that all operations are carried out by qualified personnel, in the normal manner. The specific instructions are describred in the chapter on installation. Before using the unit, take off the special protective layer which protects the stainless steel and anodyne tin parts.
ELECTRIC OVEN (5 FUNCTIONS) Switch to choose type of cooking (Fig. 2) and thermostat regulation (Fig. 3). These two switches allow you to select the type of cooking (choice of heating element) as well as temperature, according to the requirements of the recipe. The oven light stays on in all positions.
When using the oven for the first time we advise you to switch it on and allow it to heat whilst empty for approximately 45 minutes at maximum temperature. Then allow to cool down before cleaning the inside of the oven with water and a non-abrasive cleaning product. Pilot lamp When lit indicates the operation of one or more heating elements. When cooking in the oven or grill, in order to avoid over-heating, always leave the appliance’s cover open.
PROGRAMMING End of cooking numerical programmer (Fig. 7) Some models are fitted with a device which switches off the oven at the end of the cooking time programmed. The programmer has an electric clock which shows the time and a timer with an acoustic signal. Fig. 7 shows the programmer commands. All regulations are carried out by means of switches A and B.
ADVICE FOR USE OF THE HOB BURNERS Initially, use a large flame for cooking, placing the regulating switch on “ “. Then regulate the flame as necessary. The external part of the flame is much hotter than the inside (core), consequently the flame points must come into contact with the bottom of the pan. Flames which exceed the pan consume gas unnecessarily. It is not necessary to use special pans for gas cookers.
For the preparation of cakes Pre-heat the oven, unless indicated differently, for at least 10 minutes before use. Do not open the oven door when cooking dishes which must raise (e.g. raised pastries and soufflés); the jet of cold air would block the raising process. To check if cakes are cooked, insert a toothpick into the mixture; if it comes out clean the cake is ready. Wait until at least 3/4 of the cooking time has passed before doing this check.
QUANTITY g.
MAINTENANCE Before each operation, disconnect the unit. Cleaning the cooker Drops of sauce, fruit juice etc., should be removed as soon as possible with a soft cloth soaked in warm detergent water. Do not use steel wool or knives to take off layers of crust. Remove stubborn marks with a well wetted soap impregnated pad, but care must be taken not to scratch the enamel. Wash the enamelled grids with water and detergent; these can also be washed a dishwasher.
Lid cleaning All the cooker lids can be disassembled, to allow a better cleaning. Enamelled lids can be dissasembled as shown in fig. 11. As regards crystal lids, follow instructions included in the chapter named "Balancing the lid". After a proper cleaning, carefully reposition the lid into its hinges. Fig. 11 FO 0418 CARE OF CATALYTIC SIDE PANELS The catalytic side panels can neutralise most food and splashes of grease when the temperature exceeds 220˚C.
INSTRUCTIONS FOR THE INSTALLER The following instructions are meant for a qualified installer, in order that the operations of installation, regulation, and service are executed according to the existing regulations. Whenever changes are mode involving the disconnection of the machine it is necessary to proceed with maximum caution.
GAS CONNECTION Gas connection must be carried out according to the rules in force. The manufacturing company release the unit, once tested, adjusted for the kind of gas stated on the rating plate located on the back of the range, next to connection pipe. Be sure that you are going to connect the unit to the same kind of gas written on the plate.
ADAPTATION TO DIFFERENT KINDS OF GAS To adapt the appliance to a different kind of gas from the one the appliance has been set for, follow the instructions below in their order. GAS CONNECTION (Fig. 15) LPG : use the rubber pipe holder «C». Natural gas : use the pipe fitting «A». Always insert the gasket «B» (Fig. 15). Then proceed with the gas connection, as indicated in the relevant paragraphs. Fig. 14 FO 2127 HOB BURNERS NOZZLES REPLACEMENT - Remove the pan supports.
ELECTRICAL CONNECTION The unit is preset to work with a voltage of single phase 230 V. Before making the connection make sure that: — the energy power available in the user's house is sufficient for the normal supply of this appliance (see rating plate). — the unit is correctly connected to earth through a suitable plug and according to the installation country Laws. — the socket or the omnipolar switch used for the connection must be easilv reached with the installed appliance.
WHAT TO DO IF THE APPLIANCE DOESN'T WORK If the appliance doesn't work properly check the following points before asking for service: The flow of gas seems abnormal Make sure that: — the flame speader holes are not obstructed; — the pressure regulator is working; — the bottle valve is completely open. Gas smell in the room Make sure that: — the gas valve is not open; — the gas supply tube is well positioned and in good condition; remember to replace it at least once a year.