User manual

Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Door reversibility
The door of the appliance opens to the right. If you want to
open the door to the left, do these steps before you install
the appliance:
Loosen the upper pin and
remove the spacer.
Remove the upper pin and
the door.
Loosen the lower pin.
On the opposite side:
Install the lower pin.
Install the door.
Tighten the spacer and the
upper pin.
Ventilation requirements
The airflow behind the ap-
pliance must be sufficient.
5 cm
min. 200cm
2
min.
200cm
2
Installing the appliance
Caution! Make sure that the mains cable can move
freely.
Do the following steps:
x
x
If necessary cut the adhe-
sive sealing strip and then
apply it to the appliance as
shown in figure.
13mm
Ø 2,5
Drill the unit using a Ø
2.5 mm drill (10 mm
max. penetration).
Fix the square fitting to
the appliance.
20