User manual

Installation
Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on
the rating plate of the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and frequen-
cy shown on the rating plate correspond to your domes-
tic power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the
domestic power supply socket is not earthed, connect
the appliance to a separate earth in compliance with cur-
rent regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Door reversibility
The door of the appliance
opens to the right. If you
want to open the door to
the left, do these steps be-
fore you install the appli-
ance:
• Loosen the upper pin
and remove the spacer.
• Remove the upper pin
and the door.
• Remove the door.
• Loosen the lower pin.
On the opposite side:
• Install the lower pin.
• Install the door.
• Tighten the spacer and
tighten the upper pin.
Ventilation requirements
The airflow behind the ap-
pliance must be sufficient.
50 mm
min.
200 cm
2
min.
200 cm
2
Installing the appliance
Caution! Make sure that the mains cable can
move freely.
Do the following steps:
9