User Manual
17
Something not working
SYMPTOM
n The oven does not come on
n The oven temperature light does not come on
n The oven light does not come on
n It takes too long to finish the dishes, or they are
cooked too fast.
n Steam and condensation settle on the food and the
oven cavity.
n The timer does not work
n The oven fan is noisy
SOLUTION
u Check the oven is in manual operation and that both
a cooking function and temperature have been selected.
u Check the oven is wired in properly, and the socket
switch or the switch from the mains supply to the oven
are ON.
u Select a temperature with the thermostat control knob
u Select a function with the oven function control knob.
u Select a function with the oven function control knob
u Check the light bulb, and replace it if necessary (see
"Replacing the Oven Light")
u The temperature may need adjusting
u Refer to the contents of this booklet, especially to the
chapter Using the Oven.
u Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
u Check the instructions for the timer.
u Check the grease filter is correctly fitted.
u Check that shelves and bakeware are not vibrating in
contact with the oven back panel.
If the oven is not working correctly, please carry out the following checks, before contacting your local Zanussi Service
Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation,
a charge will be made even if the appliance is under guarantee.
If after all these checks, the oven still does not work,
contact your local Zanussi Service Force Centre.
When you contact them, they will need the following
information:
1. Your name, address and post code.
2. Your telephone number
3. Clear and concise details of the fault
4. The model and the serial number (which can be found
on the rating plate)
5. Date of purchase
Please note that it will be necessary to provide proof of
purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the
above checks have been made as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown.