User manual

Defrosting the freezer
A certain amount of frost will always form on the freezer
shelves and around the top compartment.
Defrost the freezer when the frost layer reaches a thickness
of about 3-5 mm.
Important! About 12 hours prior to defrosting, set the
Temperature regulator toward higher settings , in order to
build up sufficient chill reserve for the interruption in
operation.
To remove the frost, follow the instructions below:
1. Switch off the appliance.
2. Remove any stored food, wrap it in several layers of
newspaper and put it in a cool place.
Caution! Do not touch frozen goods with wet hands.
Hands can freeze to the goods.
3. Leave the door
open and insert the
plastic scraper in
the appropriate
seating at the bot-
tom centre, placing
a basin underneath
to collect the de-
frost water
In order to speed up the defrosting process, place
a pot of warm water in the freezer compartment. In
addition, remove pieces of ice that break away before de-
frosting is complete.
4. When defrosting is completed, dry the interior thor-
oughly and keep the scraper for future use.
5. Switch on the appliance.
6. After two or three hours, reload the previously re-
moved food into the compartment.
Warning! Never use sharp metal tools to scrape off
frost from the evaporator as you could damage it.
Do not use a mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer.
A temperature rise of the frozen food packs, during
defrosting, may shorten their safe storage life.
Periods of non-operation
When the appliance is not in use for long periods, take
the following precautions:
• disconnect the appliance from electricity supply
• remove all food
•
defrost
12)
and clean the appliance and all accessories
• leave the door/doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it
once in a while to prevent the food inside from spoiling
in case of a power failure.
What to do if…
Warning! Before troubleshooting, disconnect the
mains plug from the mains socket.
Only a qualified electrician or competent person must do
the troubleshooting that is not in this manual.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Problem Possible cause Solution
The appliance does not operate.
The lamp does not operate.
The appliance is switched off. Switch on the appliance.
12) If foreseen.
23