User manual

• 1. Rear edge
• 2. Front edge
• 3. Right hand side panel
The dimension of 260* mm is allowed for
fitting a 100 mm plinth below the panel. For
different plinth sizes, increase the dimension
of 260* mm accordingly.
2. Apply spacers to the hinges before
installing the appliance into the cabinet .
See picture
2
D
D
1a
1b
3. Rest the panels against the appliance.
45
4. Fit the rear brackets, taking into account the
thickness of the panels (maximum width of
unit 900 mm).
For a correct alignment make sure that the
distance between the appliance and the
cabinet is of 45 mm.
5. Secure the panels at the front.
6. Fix the squares (contained in the bag) to the
lower part of the door (references already
provided).
7. If necessary, door opening angle max 90°
can be obtained by introducing the pivots
supplied separately. See picture.
L
L
2
1
N
115°
90°
Fitting the door panels
1. Open a door a remove the bracket cover.
Undo the nuts with washers and remove the
bracket from the door.
1
2
2. Drill the small doors as shown in the figure.
1013
25
1013
25
60
4
4
60
444min.
447max.
444min.
447max.
4 5
6
7
25 25
193
193193
193
3min
214
214
• 4. Top right–and front panel
• 5. Top left-hand front panel
• 6. Bottom right-hand front panel
• 7. Bottom left-hand front panel
3. Fix the bracket to the door with the screws
contained in the bag.
4. Refit the bracket on the adjustment screws
and screw the nuts with washers without
tightening them down.
1
2
3
90
o
5. Close the door and check that the small
door is positioned at the required height,
operating the adjustment screws if
necessary.
www.zanussi.com 13