User manual

Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Authorised Service
Centre.
Electrical connection
• Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not
observed.
• This appliance complies with the E.E.C.
Directives.
Height adjustment
The height of the appliance is adjustable from
820 to 870 mm to fine up with existing kitchen
units.
820
mm
870
mm
1. Before installing the appliance between
units, adjust the height of the feet and rear
wheels. The wheels are factory set for a
height of 820 mm.
2. To align the appliance to a height of 870
mm, raise it by adjusting the feet with a
spanner, then remove the wheels and refit
them in the lowest position.
820
870
Fitting the side panels
1. Fit the brackets onto the panels in the
positions shown in the diagram.
A
17,5
1015
64
539
260*
280
15
820
15
30
B
C
541
12 www.zanussi.com