User manual

What to do if...
Problem Possible cause Solution
The appliance does not operate. The appliance is switched off. Switch on the appliance.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
Connect the mains plug to the
mains socket correctly.
There is no voltage in the
mains socket.
Connect a different electrical appli-
ance to the mains socket. Contact
a qualified electrician.
The Alarm light flashes The temperature in the freezer
is too high.
Refer to 'High Temperature Alarm.
The appliance is noisy. The appliance is not supported
properly.
Check if the appliance stands sta-
ble.
Audible or visual alarm is on. The cabinet has been recently
switched on or the temperature
is still too high.
Refer to "Door Open Alarm"or
"High Temperature Alarm".
The temperature in the appli-
ance is too high.
Refer to "Door Open Alarm"or
"High Temperature Alarm".
The temperature in the appli-
ance is too high.
Contact a qualified electrician or
contact the nearest Authorised
Service Centre.
The compressor operates contin-
ually.
Temperature is set incorrectly. Refer to "Operation" chapter.
Many food products were put
in at the same time.
Wait some hours and then check
the temperature again.
The room temperature is too
high.
Refer to climate class chart on the
rating plate.
Food products placed in the
appliance were too warm.
Allow food products to cool to
room temperature before storing.
The door is not closed correct-
ly.
Refer to "Closing the door".
Water flows inside the refrigera-
tor.
The water outlet is clogged. Clean the water outlet.
Food products prevent that
water flows into the water col-
lector.
Make sure that food products do
not touch the rear plate.
Water flows on the floor. The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet to
the evaporative tray.
10 www.zanussi.com