User manual

the plug supplied, a 13 amp ASTA approved
(BS 1362) fuse must be used.
WARNING!
A cut off plug inserted into a 13 amp
socket is a serious safety (shock)
hazard. Ensure that it is disposed of
safely.
Ventilation requirements
The airflow behind the appliance must be
sufficient.
5 cm
min. 200cm
2
min.
200cm
2
Door reversibility
WARNING!
Before carrying out any operations,
remove the plug from the power
socket.
CAUTION!
To carry out the following
operations, we suggest that this be
made with another person that will
keep a firm hold on the doors of the
appliance during the operations.
1. Loosen the upper pin and remove the
spacer.
2. Remove the upper pin and the upper door.
3. Loosen the middle hinge.
4. Remove the lower door.
5. Loosen the lower pin.
6. Install the lower pin on the opposite side.
7. Tighten the middle hinge.
8. Install the upper door.
9. Tighten the spacer and tighten the upper
pin.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the
gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.
Installing the appliance
Make sure that the mains cable can
move freely.
1. If necessary cut the adhesive sealing strip
and then apply it to the appliance as shown
in figure.
www.zanussi.com 15