User manual

Problem Possible cause Solution
Food products prevent that
water flows into the water col-
lector.
Make sure that food products do
not touch the rear plate.
Water flows on the floor. The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet to
the evaporative tray.
Temperature cannot be set. The QuickFreeze or QuickChill
function is switched on.
Switch off QuickFreeze or Quick-
Chill manually, or wait until the
function resets automatically to set
the temperature. Refer to "Quick-
Freeze or QuickChill function".
DEMO appears on the display. The appliance is in demonstra-
tion mode.
Keep the Mode pressed for approx-
imately 10 seconds until a long
sound is heard and display shuts
off for a short time.
The temperature in the appliance
is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower temperature.
The door is not closed correct-
ly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products temperature
decrease to room temperature be-
fore storage.
Many food products are stored
at the same time.
Store less food products at the
same time.
The door has been opened of-
ten.
Open the door only if necessary.
The QuickFreeze function is
switched on.
Refer to "QuickFreeze function".
The QuickChill function is
switched on.
Refer to "QuickChill function".
There is no cold air circulation
in the appliance.
Make sure that there is cold air cir-
culation in the appliance.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
www.zanussi.com 13