User manual

Problem Possible cause Solution
A square symbol is shown in-
stead of numbers on the Temper-
ature Display.
Temperature sensor problem. Contact the nearest Authorised
Service Centre (the cooling system
will continue to keep food products
cold, but temperature adjustment
will not be possible).
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp does not work. The lamp is defective. Contact the nearest Authorised
Service Centre.
The compressor operates contin-
ually.
Temperature is set incorrectly. Refer to "Operation" chapter.
Many food products were put
in at the same time.
Wait some hours and then check
the temperature again.
The room temperature is too
high.
Refer to climate class chart on the
rating plate.
Food products placed in the
appliance were too warm.
Allow food products to cool to
room temperature before storing.
The door is not closed correct-
ly.
Refer to "Closing the door".
The QuickFreeze function is
switched on.
Refer to "QuickFreeze function".
The QuickChill function is
switched on.
Refer to "QuickChill function".
There is too much frost and ice. The door is not closed correct-
ly or the gasket is deformed/
dirty.
Refer to "Closing the door".
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
This is normal, no error has oc-
curred.
The compressor starts after a peri-
od of time.
The compressor does not start
immediately after pressing the
QuickChill, or after changing the
temperature.
This is normal, no error has oc-
curred.
The compressor starts after a peri-
od of time.
Water flows on the rear plate of
the refrigerator.
During the automatic defrost-
ing process, frost melts on the
rear plate.
This is correct.
Water flows inside the refrigera-
tor.
The water outlet is clogged. Clean the water outlet.
12 www.zanussi.com