User manual

Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the am-
bient temperature corresponds to the climate
class indicated on the rating plate of the appli-
ance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
The appliance must be earthed. The power sup-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is
not earthed, connect the appliance to a sepa-
rate earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Door reversibility
The door of the appliance opens to the right. If
you want to open the door to the left, do these
steps before you install the appliance:
• Loosen the upper
pin and remove the
spacer.
• Remove the upper
pin and the upper
door.
• Loosen the middle
hinge.
• Remove the lower
door.
• Loosen the lower
pin.
On the opposite side:
• Install the lower pin.
• Install the lower
door.
• Tighten the middle
hinge.
• Install the upper
door.
• Tighten the spacer
and tighten the up-
per pin.
Ventilation requirements
The airflow behind the
appliance must be
sufficient.
5 cm
min. 200cm
2
min.
200cm
2
Installing the appliance
Caution! Make sure that the mains cable
can move freely.
Do the following steps:
11
www.zanussi.com