User manual

Ventilation requirements
The airflow behind the
appliance must be
sufficient.
6 cm
min. 200cm
2
min.
200cm
2
Installing the appliance
Caution! Make sure that the mains cable
can move freely.
Do the following steps:
x
x
1
If necessary cut
the adhesive sealing
strip and then apply it
to the appliance as
shown in figure.
1
2
2
Install the appli-
ance in the niche.
Push the appliance in
the direction of the ar-
rows (1) until the up-
per gap cover stops
against the kitchen
furniture.
Push the appliance in
the direction of the ar-
rows (2) against the
cupboard on the op-
posite side of the
hinge.
44mm
4mm
3
Adjust the appli-
ance in the niche.
Make sure that the
distance between the
appliance and the
cupboard front-edge
is 44 mm.
The lower hinge cov-
er (in the accessories
bag) makes sure that
the distance between
the appliance and the
kitchen furniture is
correct.
Open the door. Put
the lower hinge cover
in position.
I
I
4
Attach the appli-
ance to the niche with
4 screws.
5
Remove the cor-
rect part from the
hinge cover (E). Make
sure to remove the
part DX, in the case
of right hinge, SX in
opposite case.
E
E
D
C
B
6
Attach the covers
(C, D) to the lugs and
the hinge holes.
Install the vent grille
(B).
Attach the hinge cov-
ers (E) to the hinge.
14
www.zanussi.com