User manual

AB
C
D
E
Important! The wires in the mains lead are
coloured in accordance with the following code:
A Green and Yellow: Earth
C Brown: Live
D Blue: Neutral
As the colours of the wires in the mains lead of
this appliance may not correspond with the col-
oured markings identifying the terminals in your
plug, proceed as follows:
1. Connect the wire coloured green and yel-
low to the terminal marked either with the
letter “E“ or by the earth symbol
or col-
oured green and yellow.
2. Connect the wire coloured blue to the ter-
minal either marked with the letter “N“ or
coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the “L“ or col-
oured red.
4. Check that no cut, or stray strands of wire
is present and the cord clamp E is secure
over the outer sheath.
5. Make sure the electricity supply voltage is
the same as that indicated on the appliance
rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
fitted B. In the event of having to change the
fuse in the plug supplied, a 13 amp ASTA ap-
proved (BS 1362) fuse must be used.
Warning! A cut off plug inserted into a 13
amp socket is a serious safety (shock)
hazard. Ensure that it is disposed of safely.
Door reversibility
The door of the appliance opens to the right. If
you want to open the door to the left, do these
steps before you install the appliance:
1
Loosen the upper
pin and remove the
spacer.
2
Remove the upper
pin and the upper
door.
S
3
Loosen the middle
hinge.
4
Remove the lower
door.
4
Loosen the lower
pin.
On the opposite side:
1
Install the lower
pin.
2
Install the lower
door.
3
Tighten the middle
hinge.
4
Install the upper
door.
5
Tighten the spacer
and the upper pin.
13
www.zanussi.com