User manual

Problem Possible cause Solution
The temperature of the room that
contains the appliance is too high
for efficient operation
Try to reduce the temperature in the
room where the appliance stands
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
It is too warm in the refrig-
erator
The Temperature Regulator may be
set incorrectly
Set a lower temperature
The door does not close tightly or it
is not shut properly
Check if the door closes well and the
gasket is undamaged and clean
Food placed in the appliance was
too warm
Allow food to cool to room tempera-
ture before storing
Large quantities of food to be
cooled were put in at the same time
Insert smaller quantities of food to be
cooled at any one time
There is no inside cool air circula-
tion
Provide inside cool air circulation
It is too cold in the refrig-
erator
The Temperature Regulator may be
set incorrectly
Set a higher temperature
It is too warm in the freez-
er
Temperature Regulator may be set
incorrectly
Set a lower temperature
The door does not close tightly or it
is not shut properly
Check if the door closes well and the
gasket is undamaged and clean
Large quantities of food to be frozen
were put in at the same time
Insert smaller quantities of food to be
frozen at any one time.
Food placed in the appliance was
too warm
Allow food to cool to room tempera-
ture before storing.
Products to be frozen are placed
too closely to each other
Place the products in a way so that
cold air could circulate among them
It is too cold inside the
freezer
Temperature Regulator may be set
incorrectly
Set a warmer temperature
The appliance does not
work at all. The appliance
does not cool at all. Nei-
ther cooling nor lighting
works
The appliance may be switched off Switch on the appliance
Plug is not connected to the mains
socket properly
Connect the mains plug properly
Power does not reach the appliance Try connecting another electrical de-
vice to the power outlet
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Call an electrician
11
www.zanussi.com