User manual

Replacing the lamp
1
Disconnect the mains plug from the mains
socket.
2
Press on the rear hook and at the same time
slide the lamp cover in the direction of the ar-
row.
3
Replace the lamp with one of the same
power and specifically designed for household
appliances. (the maximum power is shown on
the light lamp cover)
4
Install the lamp cover by sliding it into its
original position.
5
Connect the mains plug to the mains sock-
et.
6
Open the door. Make sure that the lamp
comes on.
2
1
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension of the recess
Height 1780 mm
Width 560 mm
Depth 550 mm
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
9
www.zanussi.com