User manual

13mm
Ø 2,5
Drill the unit using a Ø 2.5
mm drill (10 mm max. pen-
etration).
Fix the square fitting to the
appliance.
1
2
Install the appliance in the
niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture. Make sure that
the distance between the
appliance and the cup-
board front-edge is 44 mm.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge. Make sure that the
clearance between the ap-
pliance and the cupboard
is 4 mm.
44mm
4mm
Adjust the appliance in the
niche.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen furni-
ture is correct.
Open the door. Put the low-
er hinge cover in position.
I
I
Attach the appliance to the
niche with 4 screws.
Push the sealing strip be-
tween the appliance and
the adjacent cabinet.
Remove the correct part
from the hinge cover (E).
Make sure to remove the
part DX, in the case of
right hinge, SX in oppo-
site case.
B
E
E
C
D
Attach the covers (C, D) to
the lugs and the hinge
holes.
Install the vent grille (B).
Attach the hinge covers
(E) to the hinge.
Ha
Hb
Hc
Hd
Disconnect the parts (Ha),
(Hb), (Hc) and (Hd).
24