User manual

Installing the appliance
Caution! Make sure that the mains cable
can move freely.
Do the following steps:
x
x
If necessary cut the adhesive sealing strip and
then apply it to the appliance as shown in figure.
2
3
Ø 2.5 mm
13 mm
1
Drill the appliance using a Ø 2.5 mm drill (10
mm max. penetration).
Fix the square fitting to the appliance.
1
2
Install the appliance in the niche.
Push the appliance in the direction of the arrow
(1) until the upper gap cover stops against the
kitchen furniture.
Push the appliance in the direction of the arrow
(2) against the cupboard on the opposite side of
the hinge.
10
www.zanussi.com